VHDL写的串口，很好用，程序非常简单，可以调试用

使用Verilog编写的正弦波生成工程，使用ROM核产生，利用mif文件(Written using Verilog sine wave generation projects using ROM nuclear generation, use mif file)

基于FPGA的PWM控制器设计，包含ADC0820模块，按键扫描，PID，PWM控制器等模块，VHDL语言完成，已仿真通过(PWM controller design based on FPGA, including ADC0820 module, key scan, PID, PWM controllers and other modules, VHDL language completed, through simulation)

the 8 bit alu by verilog

基于FPGA的调制，实现了QPSK调制，所用芯片为Artera的CycloneIIEp2C5T114C8-FPGA-based modulation, realize the QPSK modulation, the chip used for Artera

本设计主要用来进行图像采集处理，通过摄像头采集图像信息，经过插值算法后存储到外部SDRAM，然后读取图像数据，进行边缘滤波处理后经VGA输出到屏幕上。(This design is mainly used for image acquisition and processing,through the camera capture image information,after interpolation to the external memory after the SDRAM,and then read the image data processed by the edge filter VGA output to the screen.)

这是一个FPGA的简单例程，主要是基于FPGA的232串口通信的例程-This is a simple routine FPGA is mainly based on FPGA-232 serial communication routines

使用Verilog编写的时间同步模块，解决位同步问题，ISE12.2下编译通过(Time synchronization module written in Verilog, bit synchronization issues under ISE12.2 compiled by)

mux2to1.vhd二选一电路mux2_1.vhd二选一电路mux2_1.bdf二选一电路mux3to1.vhd三选择电路mux3to1_1.vhd三选一选一个电路mux4to1.vhd 4

单片机与ＦＰＧＡ的通信　 功能 :单片机控制写FPGA一字节数据 单片机控制写FPGA一字节数据时钟 (注意读写数据端口可复用,也可分用) 单片机控制发送数据端口 -MCU and FPGA communication functions: SCM control FPGA to write a byte of data SCM control FPGA to write a byte of data clock (Note that the read and write data ports can be re-used, but also can be divided into use) SCM control to send data port

通信基带信号发生器的设计，采用单片机输入频率和波形，在FPGA中实现频率和波形生成-Communications base-band signal generator design, the use of single-chip input frequency and waveform, in the FPGA to achieve the frequency and waveform generation