To increase simulation speed, ModelSim® can apply a variety of optimizations...

在FPGA上编写的通过SPI总线配置外部DAC芯片DAC5686的程序，通过板级调试，验证可用。程序通过状态机实现，将需要配置的寄存器值转为SPI总线的数据格式发送出去。 (Configure external DAC chip DAC5686 via SPI bus program on FPGA written by board-level debugging, verification is available. Program through the state machine, you will need to configure the register values 椠渀琀漀 SPI bus data format sent.)

在Qaurtus环境下用Verilog输入实现64QAM信号的发生，用MATLAB协助验证，观察了PN序列对应的星座图。(Simulating generation of 64QAM RF Signal in Quartus II IDE,identified with MATLAB,constellation gram displayed.)

Uedit中对Keil C51、A51、avr、x86汇编以及VHDL语言的突出显示格式文件-Uedit of Keil C51, A51, avr, x86 VHDL compilation of the highlights format

用状态机实现一序列检测器，即检测到串行码{1110010}后，检测器输出1，否则输出0； -State machine used to achieve one sequence detector, which detects the serial code (1110010), the detector output 1, otherwise output 0

一份带有FIFO缓存的UART源码，采用verilog编写，实现批量数据的传输，数据缓存量可以通过修改源码中的FIFO的深度来改变。(This is a UART with FIFO. The UART is programmed using verilog, it can transmit or receive batch data. The amount of data buffered can be changed by changing the depth of FIFO.)

I2C is a two-wire, bi-directional serial bus that provides a simple and efficient method of data exchange between devices.

自己在ISE下用VHDL写的UART，简单，易懂(in ISE using VHDL was the UART, simple, understandable)

verilog写的频率计程序的计数模块,-Verilog written procedures for counting frequency meter module,

在开发板EGO1上实现的图形记忆游戏，白块按下确认建，黑色块不按确认键(memory game in verilog)

Advanced FPGA Design Architecture, Implementation, and Optimization