vb6.0-yanshi

实现射线源控制，包括电压，电流，大小焦点。还有图片按钮。(Achieve-ray source control, including voltage, current, the size of the focus. There are picture buttons.)

说明：  温湿度串口检测程序，实现对数据的读取和检测(Temperature and Humidity Serial Port Detection Program for Data Reading and Detection)

说明：  本程序基于单片机实现RTC实时时钟，简单易懂(The program is based MCU RTC real time clock, easy to understand)

基于TI公司的msp430g2553单片机的lcd显示程序，好用(Based on TI company s msp430g2553 MCU LCD display program, absolutely easy to use)

RAID卡的测试程序，写的不好哈，请大家原谅，(RAID card test procedures and writing bad Kazakhstan,)

此文件夹有高通滤波，低通滤波，带通滤波，带阻滤波，三角信号发生器，正弦信号发生器，三角波发生器，三角波转换成余弦，等等tina的源程序，适合广大爱好者！(This folder has a high pass filter, low pass filter, band-pass filtering, band stop filtering, triangular signal generator, sine wave generator, triangle wave generator, triangle wave into a cosine, so tina source for the majority of fans !)

STC12C5204AD单片机控制单个二极管闪烁源代码，二极管由138译码器使能，另一端单片机IO口控制，采用延时程序，是单片机初学者很好的学习源代码(STC12C5204AD flash microcontroller source code to control a single diode, diode 138 by the decoding is enabled, the other end of the single-chip IO port control, using the delay procedure is a very good chip for beginners to learn the source code)

stm8系列单片机，控制八位数码管按键计数(stm8 series microcontrollers, digital control buttons eight counts)

YL_3串行数码管显示时钟，74HC595，8位，显示时分秒，自动计数。(YL_3 serial digital display clock, 74HC595, 8 bit display minutes and seconds, automatic counting.)

51单片机的串口通信程序，来自于开发板，VC环境下编写。(51 the Serial communication program, and from the development board, VC environment prepared.)