C51实现的FAT32文件系统

友善臂开发板上使用的触摸屏驱动，s3c2410，2.6内核下使用-The development of friendly arm on the board using touch-screen driven, s3c2410, 2.6 kernel use

这是一个接收单片机数据的软件,通过对接收的数据分析来显示相应的LED.目前只能显示一个LED,有时间会全部做好的,目前接收到的数据为0A0B0C,也就是从单片机发出来的数据为10,11,12,单片机的程序是a-This is a single-chip microcomputer software to receive, through the analysis of data received to display the corresponding LED. Currently only display a LED, will all have time to do a good job of currently received data 0A0B0C, that is, from a single machine sent to the data for 10,11,12, SCM process is a

是一款DA板卡的控制界面的原代码. 用VISUAL BASIC编程-Card is the control interface of the original code. Visual Basic

用C-BASEIC语言编写的805X单片机计算子程序P=A0+A1*X+A2*X*X+A3-with C-language BASEIC the 805X MCU calculation subroutine P = A0 A1 A2* X* A3* X* X* X* X* X

基于51单片机实现的M序列发生器（伪随机序列），在Keil编程环境下的源码-Based on 51 single-chip realization of M sequence generator (pseudo-random sequence), in Keil of-source programming environment

利用L293D驱动步进电机，正转，反转，调速等-Make use of stepper motor driver L293D is transferred, reverse, speed control, etc.

EEPROM仿真器有原理图，源代码等详细说明，是硬件调试的好帮手

DS18B20,我已经做过,显示正确!欢迎下载!-DS18B20, I have already done, showing the correct! Welcome to download!

can总线详细设置资料，从网络转来的！呵呵，看看可不可以用！-Bus details can set up information transferred from the network! Oh, look at the possible use!

利用传感器将模拟信号转成数字信号.列举常用的ADC0809并详细讨论A/D在单片机系统中的应用.-The use of sensors to the analog signal into digital signal. ADC0809 commonly cited and discussed in detail the A/D in SCM systems.