LCD应用显示keil编写非常实用的C程序

OCM12864的基本使用方法和实现多菜单的实现。-OCM12864 the basic use of methods and the realization of multi-menu.

ST9720控制器的12864液晶程序，同时兼容12232，本程序使用串行接法。只需三个管脚。-ST9720 LCD controller 12864 program is compatible with 12232, this program uses a serial access method. Just three pins.

全量程交直流无档电压表的设计 这里只给出了系统设计的方案 带有程序流程图-Wide-range AC-DC voltage meter free stall design here only gives the system design program with a program flow chart

一反馈报警器的完整原程序,用于负载量变化的检测与报警.-a feedback report of the original integrity of procedures for loading change detection and alarm.

同为电脑遥控器，也是AVRUSB制作，但是带有触摸方式！-The same for the computer remote control, but also AVRUSB production, but with a touch-way!

AVR M32 Ethernet仿真实例，通过Proteus仿真，送给想学微控制器网络通讯的而没有硬件的朋友-AVR M32 Ethernet simulation example, through the Proteus simulation, a gift I wanted to learn microcontroller network communications hardware and not a friend

上位机是VB设置成的界面；下位机是用C编释的51单片机的温度采集模块。-VB PC are set to the interface under the C-bit machines are used for release of 51 single-chip temperature acquisition module.

用过采样和求均值技术提高模数转换器的分辨率.pdf-----针对目前单片机内嵌的模／数转换器的分辨率太低，而外接高分辨率成本又太高的情况，提出了用“过采样和求均值”的技术来使在有用的测量频带内的信噪比得到改善，从而提高测量的分辨. 率。并利用 60 - 7 0 /对其结论进行仿真，且在单片机上予以实现，结果表明测量分辨率明显提高。-Sampling and averaging techniques used to improve the resolution of ADC. Pdf----- targeted at the embedded microcontroller A/D converter resolution is too low, while the external high-resolution costs are too high situation, put forward with " Oversampling and Averaging" technology to make useful measurements in the frequency band signal to noise ratio to be improved, thereby enhancing the measurement resolution. rate. And a 60- 7 0/simulation of its conclusions, and in the SCM to be achieved, results show that the measurement resolution has improved significantly.

PKE（被动无钥门禁系统，汽车车门控制）整个系统遥控部分源代码。-PKE (passive-keyless-entry system, car door control) remote part of the whole system source code.

这是“led广告屏”程序，已经成功调试，希望对大家有用，谢谢！（最好配合51单片机和伟福编译器）-"led advertising screen" program has been successfully tested and we hope to useful, thank you! (Preferably with 51-fu SCM and compiler)