一个电子产品开发时的部分c代码E!绝对能用!

单片机系统用c语言编写关于两个PIC之间的通信的设计。。。本程序采用的单片机型号为PIC16F8- Single-SCM systems c language on the communication between two PIC design. . . This procedure used for the PIC16F877 microcontroller model

C8051F系列CPU，解决128K程序调试例程，用C语言编写。-C8051F series CPU, resolve 128K program debugging routines, using C language.

时钟芯片DS1302和在12864lcd上显示当前时间-DS1302 clock chip and display the current time 12864lcd

飞思卡尔智能小车 AD驱动程序示例代码 芯片为MC9S12XS128-AD Freescale" s Smart car driver sample code chip MC9S12XS128

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

单片机IO口模拟UART演示程序，使用74HC164串行显示数据-Single-chip analog IO port UART demo program, the use of 74HC164 serial display data

AVR俄罗斯方块程序:游戏区是18*15格，3*3点阵一格，右边有下一个图形显示和所消行数的显示

IDE-ATA硬盘驱动器的ARM控制源代码-IDE-ATA hard disk drives to control the source code of the ARM

汇编程序的一些非常实用的初始化程序-Compilation of some very practical procedure initialization procedure

单片机课程设计PPT,汇编语言,电子书籍-SCM curriculum design PPT.rar