使用单片机的比较器进行AD转换，采用喜歌马、带她方式

给公司写的点焊机测试程序，用于产生4路PWM波-Write to the company" s spot welder testing procedures used to produce 4-channel PWM wave

CAN控制器SJA1000的标准帧，BsaicCAN模式，调好的初始化、发送、接收底层程序，大家共享。-CAN controller SJA1000 standard frame, BsaicCAN mode, tune good initialization, send, receive the bottom of procedures, for all to share.

atmel官方的at91sam7x256芯片在iar编译环境下的全部演示代码，以工程方式提供。-official at91sam7x256 atmel chip iar build environment in the whole of the demonstration code to the project provided.

nrf24e1有关PWM的源码程序，通过keil c验证，在相应的开发板上调试运行过-nrf24e1 the PWM of the source program, verified by keil c, in the corresponding development board debug run-off

* BL-TFT240320-BOARD 2.8/3.2" board * LCD 240x320 3.2-inch QVGA 262k TFT-LCD module * Resolution of 240RGBx320 dots * 262k TFT Color LCD * LCD driver is SSD1289 * Touch screen controller ADS7843 * SD card slot with led card insert detection * SPI pin interface * ARDUINO pin support * Black light control with hardware or software control * 8/16-bit interface for microcontrollers * 40 pin Interface * Power input voltage 5Vdc * Frame Cover * Dimensions:68mm x 97mm - * BL-TFT240320-BOARD 2.8/3.2" board * LCD 240x320 3.2-inch QVGA 262k TFT-LCD module * Resolution of 240RGBx320 dots * 262k TFT Color LCD * LCD driver is SSD1289 * Touch screen controller ADS7843 * SD card slot with led card insert detection * SPI pin interface * ARDUINO pin support * Black light control with hardware or software control * 8/16-bit interface for microcontrollers * 40 pin Interface * Power input voltage 5

关于SPLC501C的液晶编程，实现了音乐动画，有参考价值-on SPLC501C LCD programming, animation realization of the music, a reference value

C8051F340/1/2/3/4/5/6/7/8/9/A/B devices are fully integrated mixed-signal System-on-a-Chip MCUs designed specifically for USB applications.-C8051F340/1/2/3/4/5/6/7/8/9/A/B devices are fully integrated mixed-signal System-on-a-Chip MCUs designed specifically for USB applications.

MSP430F2274单片机C语言程序实例-MSP430F2274 Singlechip C language program example

这是一个PID算法在DSP上运行的程序,并且调试通过-This is a PID algorithm in the DSP program running, and debugging through

29个单片机实验（转载）-29 SCM experiment (reproduced)