实用的程序代码，希望对大家有用，已经调试通过

FPGA 控制MPU6050陀螺仪传感器，通过串口把数据打印出来(FPGA controls the MPU6050 gyroscope sensor and prints out the data through the serial port)

---------------------------------------------------------------------------

八位并行数据转换为串行数据依时钟信号串行输出(Eight bit parallel data to serial data)

SDRAM驱动器，自己项目利用的，已经经过实际验证(sdram controller)

自己编写的经过QuartusII验证的Verilog HDL程序，可以实现常见功能-After QuartusII their written procedures for verification of the Verilog HDL, can achieve common features

采用VHDL编写的一个简单的UART-using VHDL prepared a simple UART

THIS IS A SOURCE CODE FOR LIFT IN VHDL LANGUAGE

n bit generic shift registers

说明：  XC7A35TCSG324-1的Verilog频率计程序，支持十分频，支持切换内外信号输入(Verilog frequency meter program of xc7a35tcsg324-1 supports decadal frequency division and switching internal and external signal input)