脉冲检测

用Verilog 写一个8x16 的FIFO，完成先入先出的功能，并且在FIFO读空时输出EMPTY 有效信号，读指针RP 不再移动；FIFO 写满时输出FULL 有效信号，并且即使WR 有效也 不再向存储单元中写入数据(写指针WP 不再移动)。 (NO)

VHDL Programmes -2 for dumping on FPGA

基于FPGA用verilog语言实现16点FFT(16-point FFT FPGA-based verilog language)

用vhdl写实用96例子, 有RAM，PID 等(Using VHDL to write practical examples of 96, there are RAM, PID and so on)

基于SHA-1算法和DS28E01加密芯片的FPGA系统设计，该上传文件为整个设计的系统文件。Quarter软件编程的Verilog程序，包含仿真调试界面。(Design of FPGA system based on SHA-1 algorithm and DS28E01 encryption chip。)

fpga串口的接收程序基于verilog语言拿走不用谢。(The receiving program of FPGA serial port is based on Verilog language.)

说明：  示波器设计，首先，AD模块对模拟信号进行采样，触发电路根据采样信号判断触发条件。满足触发条件后，连续采样一定数量的点（本系统中为640个点），存储到RAM中。峰峰值、频率计算模块对RAM中储存的波形数据进行计算，得到波形的频率以及峰峰值；VGA模块将波形显示出来，并显示计算得到的峰峰值和频率数值。(Firstly, the ad module samples the analog signal, and the trigger circuit judges the trigger condition according to the sampling signal. After meeting the trigger conditions, a certain number of points (640 points in this system) are sampled continuously and stored in RAM. The peak to peak and frequency calculation module calculates the waveform data stored in RAM to obtain the frequency and peak to peak of the waveform; the VGA module displays the waveform and displays the calculated peak to peak and frequency values.)

vivado2017.4下的串口通信的Verilog源码，一次传输8位，包括发送模块，接受模块，顶层模块(Verilog source code for serial communication under vivado 2017.4, which transmits 8 bits at a time, including sending module, receiving module and top module)

wallace tree multiplier in verrilog

un controller pi par le langage VHDL xilinx ise design 13.2