canbus verilog实现，原代码文件

1．初始状态为4个方向的红灯全亮，时间1秒。 2．东、西方向绿灯亮，南、北方向红灯亮。东、西方向通车，时间30秒。 3．东、西方向黄灯闪烁，南、北方向红灯亮。时间2秒。 4．东、西方向红灯亮，南、北方向绿灯亮。南、北方向通车，时间15秒。 5．东、西方向红灯亮，南、北方向黄灯闪烁。时间2秒。 6．返回2，继续运行。 -1. Initial state for four whole direction of the red lights lit up, a second time. 2. East and West to the green, in the south, north to the red light. West and the East to open in time for 30 seconds. 3. East and West to the blinking yellow light, in the south, north to the red light. Time 2 seconds. 4. East and West to the red light, in the south, north to the green. South and North to the opening time of 15 seconds. 5. East and West to the red light, in the south, north to the flashing yellow light. Time 2 seconds. 6. Return 2, continued to operate.

电梯控制 记忆，上升下降停站 超载报警故障.....。-Verilog EDA dianti

这是基于Quartus2 开发环境和verilog hdl语言写的38译码器(This is based development environment and Quartus2 verilog hdl language used to write decoder 38)

基于芯片MAX502的十二位并行DAC芯片的程序，利用FPGA中的ROM查表进行数据存储-Based on 12 of the MAX502 chip DAC chips in parallel procedures, the use of FPGA in the ROM look-up table for data storage

verilog 驱动TLC5510代码，TLC5510是高速的AD，可达20MHz(verilog code driven TLC5510, TLC5510 is a high-speed AD, up to 20MHz)

用VHDL语言设计四位全加器，有低位进位和高位进位。-VHDL language with four full-adder design, there are low and the high binary binary.

用vhdl语言编写的数字逻辑alu设计，实现包括逻辑运算乘法、加法和移位的运算功能，加入流水线处理，适用于初学硬件语言的同学们

ANALYSIS OF D-FLIPFLOPS

在FPGA上实现声卡接口，电子琴，滤波比较器，最终实现语音通信 -In the FPGA to achieve the sound card interface, flower, filter comparators, the eventual realization of voice communications

modelsim的一个非常好的教程，有程序源码，PPT，word教程-ModelSim