第 一章 电路原理分析 1

凌阳单片机的语音程序2，供学习凌阳单片机的学习者参考-Sunplus SCM voice two procedures for learning Sunplus SCM reference learners

51单片机上的DS1302驱动，相关的LCD驱动可以在我发布的其它驱动中找到。-51 MCU on the DS1302 drive LCD driver can be related to the other drivers I have found.

编译环境：ICC AVR 6.31A 单片机：AT90S8515 PC.0出音乐信号，INT0，INT1分别接下一首、播放/暂停键 开机处于暂停状态，按下播放/暂停键开始放音，自动播放完8首，会再进入暂停状态。 所有的暂停状态都采用掉电模式。 -build environment : ICC AVR microcontroller 6.31A : AT90S8515 PC.0 musical signal INT0, INT1 respectively took one, Play/Zantingjian Boot suspended, press Play/Zantingjian start of audio, automatic broadcast End 8, will enter the state. All the suspended power-down mode is used.

=== =时钟20:6=== === == 应先初始化状态寄存器 tx1714 EQU 7FFH PA EQU 05H PB EQU 06H PC EQU 07H PD EQU 20H IAR EQU 00H 间接寻址寄存器 TMR0 EQU 01H 定时器 STATUS EQU 03H 状态寄存器 BSR EQU 04H bank选择寄存器 PORTA EQU 05H I/0端口寄存器 PORTB EQU 06H I/0端口寄存器 PORTC EQU 07H I/0端口寄存器 PORTD EQU 20H I/0端口寄存器 PULL EQU 21H PULL-High上拉寄存器 WAKEUP EQU 22H 唤醒控制寄存器－－被用来设定watchdog允许和禁止 IRQM EQU 23H 中断屏蔽寄存器 IRQF EQU 24H 中断标志寄存器 WDTSEL EQU 25H -=== === = clock 20 : 6 === === === == should first register initialization state tx1714 EQU 7FFH EQU PA PB EQU 05H 06H 07H PC EQU PD EQU 20H IAR E QU 00H indirectly addressable registers TMR0 EQU 01H timer STATUS EQU Mr send state BSR EQU-deposit bank in the 04H choice Register PORTA EQU 05H I/O ports Register P ORTB EQU 06H I/O ports Register PORTC EQU 07H I/O ports Register POR TD EQU 20H I/O ports Register PULL EQU 21H PULL-High pull Register WAKEUP EQU 22H awaken control registers-- were used to set watchdog allowed and prohi

用C51写的EEPROM24c32（I2C）芯片读写程序-C51 written by EEPROM24c32 (I2C) chip to read and write procedures

51/52单片机实现的广告灯的左移右移,仿真以及源码都很全。源码为c以及汇编。-51/52 Singlechip ads lights left shifted to right, simulation as well as the source is very wide. C as well as the source for the compilation.

C51 用PCA 模拟串口，很有参考价值得源码-C51 with PCA serial analog, a valuable source

CPU卡读写，符合7816标准。经测试完全可以使用。-CPU card reader, in line with the 7816 standards. Been tested and can be used.

PIC单片机的指令集，其中包括了12位（基本级）、14位（中、高级）产品的全部指令！-PIC microcontroller instruction set, which included a 12 (basic level), 14 (senior) products all directions!

AVR单片机实现液晶显示的程序代码-AVR MCU LCD procedure code