智能电加热定时控制电路原程序,智能电加热定时控制电路原程序...

18B20程序，用C语言编写，代码结构清晰，语言简练，供新手学习。-18B20 procedure, using C language, code structure clear, concise language for the novice to learn.

常用串行EEPROM的编程应用，EEPROM是"Electrically Erasable Programmable Read-only"（电可擦写可编程只读存储器）的缩写，EEPROM在正常情况下和EPROM一样，可以在掉电的情况下保存数据，所不同的是它可以在特定引脚上施加特定电压或使用特定的总线擦写命令就可以在在线的情况下方便完成数据的擦除和写入-Commonly used application of serial EEPROM programming, EEPROM is Electrically Erasable Programmable Read-only (Xinhua EPROM) acronym, EEPROM under normal circumstances and EPROM, as in the case of power-down to save data , What is different is that it can exert in a particular pin on a specific voltage or use specific bus write command can be in the case of online data to facilitate the completion of the erase and write

本程序实现了基于74ls373锁存器的LED显示系统的Protues仿真。实例简单明了，适合初学者，在程序基础上进行扩展。-This procedure based on the implementation of the LED latch 74ls373 Display System Simulation Protues. Examples of simple and clear, suitable for beginners, in the procedures conducted on the basis of the expansion.

12864中文字库液晶演示程序 MS12864R 测试程序(串口) 连线表 CPU=89C52 SystemClock=12Mhz CS=P3.0 SCLK=P3.1 SID=P3.2 Reset=RC in Board

新华龙020 的内置spi0。驱动16位精度dac8831的程序，采用单端方式输出正弦波-Hualong 020 new built-spi0. Dac8831 drive 16-bit accuracy of the procedures, the use of single-ended sine wave output

伺服马达控制的C51程序。 文件： sifu*.c sifu*.Uv2 sifu*.hex 等相关文件。-Servo motor control of the C51 program. File: sifu*. csifu*. Uv2sifu*. hex and other relevant documents.

飞思卡尔 智能小车PWM波发生模块驱动示例程序 芯片MC9S12XS128-Freescale" s Smart car PWM wave occurred Module Driver sample application chip MC9S12XS128

MS51单片机的一些设计包含原理图和源代码，可在proteus下仿真。。 备注：这些设计的源码是使用汇编语言编写的。-MS51 MCU contains a number of design schematics and source code, under the simulation in Proteus. . Note: these designs is to use the compilation of the source language.

51单片机对AT45D041卡（大容量IC卡）的读写程序 把.rar改成.c即可-51 micro AT45D041 card (large-capacity IC card) reading and writing procedure. Rar changed. C can

用单片机16F877A外接MAX518实现正弦波输出-16F877A MCU external realize sinusoidal output MAX518