用msp430 对128×64的LCD的完全操作，

本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.

（一）OCMJ8X15D的触摸屏是用模块内部控制器控制的， （二）OCMJ15X20D（V3.2）的触摸屏是用ADS7843控制的，该控制器已集成在模块上，模块已留出ADS7843的控制线供客户使用（OCMJ15X20D上的J5脚），

基于8051的生产线记件系统，外部中断1触发，6位LED显示，EEPROM保存数据。-Based on the 8051 piece production line system, one external interrupt trigger, 6 LED display, EEPROM data is preserved.

新手关于单片机的-newcomers on the MCU

mega128的bootloader程序,上位机采用vb,下位机采用gcc编译-mega128 the Bootloader procedures PC using vb. under the crew used gcc

包括电路图和源程序，汇编语言编写。JP1、JP2、JP3为电机接口，JP5为投币器接口，JP4为指示灯接口-including circuit diagrams and source code, written in assembly language. JP1, JP2, JP3 for electrical interfaces, JP5 for the coin interface, the interface indicator of JP4

本程序是利用arm7控制双色led点阵屏的显示源码。是用ADS软件开发的，希望对各位有用-This procedure is the use of ARM7 control of two-color dot matrix led display screen source. ADS is a software development, in the hope that useful

基于DP51与DP12的USB的开发程序-DP51 and DP12 based on the USB development process

pcf s I2C softpake ,form zlgmcu.com

单片机简易数控电源no interupt 源代码-Single-chip digital power supply simple no interupt source code