简易频率计，一个中断，一个定时器，适合初学者学习中断、定时器，动态扫描显示。...

samsung arm2440开发板 数模转换测试程序，程序开发平台为qt平台开发环境为linux系统-samsung arm2440 development board digital-to-analog conversion test procedures, procedures for qt platform development platform development environment for linux system

数控直流稳压电源，单片机实现直流数控稳压电源,可调电压为0-12伏,步进为0.1伏

Atmega8L控制CC1020 TI的另外一款使用很多的RF ＩＣ。-Atmega8L control CC1020 TI to use another one of the many RF IC.

keilc + proteus 并行口设计指示灯实验 要求：掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.

一个用来作软件仿真用的KEIL的程序，有仿真的过程-used as a software simulation of KEIL procedures and the process simulation

EDN板子做的1602显示时钟 温度，可参考-EDN board to do the 1602 show the clock temperature, may refer to

THE BASIC ADC PROGARM OF ATMEGA16L ,USE THE PA0 TO PA7 TO DISPLAY THE DATA in THE LCD

RS485的C51程序 中断 寄存器设置 接收和发送数据，希望对大家有用-RS485 interrupt register of the C51 program set to receive and send data, in the hope that useful

该算法经运行，无任何问题，可用于解决模拟退货算法求解车辆路线问题-The algorithm by running without any problems, can be used to solve the simulation algorithm Return Vehicle Routing Problem

利用此程序可以实现关于红外线的编码与解码-This process can be achieved using infra-red about the encoding and decoding