S3C2410下的NandFlash实验代码!

bf535 rtc example code.

x86平台的usb摄像头驱动程序，把dll文件加入到系统中就可以驱动摄像头了，芯片为ovt511的-OVT511 s Driver for USB Cam on x86 platform. Just copy the DLL file to your system and drive the Cam!

arm――启动代码-arm-- bootcode

稳定的单片机键盘程序，支持长按，连击等操作！-Stable MCU Keyboard Program

1、arm7芯片2148驱动大液晶 2、ym320240的液晶驱动 3、I2c通信at24c256 4、各种字符的显示-1, arm7 chip liquid crystal 2148 driver 2, ym320240 LCD Driver 3, I2c communications at24c2564, various characters in the display

该程序是MPC860的SCC2用作HDLC模式的驱动程序。供大家参考。-that the procedure was MPC860 SCC2 HDLC mode for the driver. For your reference.

是三星的S3C4510开发板的使用文挡，有详细的设计资料，很好。-is Samsung"s S3C4510 development board block the use of text, a detailed design information, very good.

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4,每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

ARM7―LPC2124―串口开发实例 基于Keil uVision3源码开发再进行Proteus 7 联合对ARM7―LPC2124―I2C硬件电路仿真-ARM7-LPC2124-developed examples of serial Keil uVision3 source development based on further joint Proteus 7 on ARM7-LPC2124-I2C hardware circuit simulation

2410开发板配套实验程序第一集，请下载使用-2410 development board supporting experimental procedure the first episode, please download