A simple C program to strobe the LEDsvia Port D. The strobe rate is to be set by...

Keil_C51程序,C8051实现的TCP/IP功能源码，使用keilC51，含网页测试程序。-Keil_C51 procedures, C8051 realize the TCP/IP function of source, the use of keilC51, including test procedures page.

1. API 为FlashDSO的接口,包含 FlashDSOAPI.DLL, FlashDSOAPI.LIB,FlashDSOAPI.H 使用手册 2.TestAPI 为FlashDSO API 的测试例程．-1. For FlashDSO API interface, included FlashDSOAPI.DLL, FlashDSOAPI.LIB. FlashDSOAPI.H manual 2.TestAPI FlashDSO API for the test test routines.

MIPS处理器VHDL代码，实现加法，减法乘除等运算，可综合-MIpscup vith vhdl

AVR Studio 4 中文帮助 这个是翻译的原版英文的-AVR Studio 4

ARM7核 S3C44B0 NAND FLASH烧写配置文件。 -ARM7 core S3C44B0 NAND FLASH Shaoxie configuration file.

三星S3C2440处理器的Camera控制器驱动-Samsung S3C2440 processor Camera Controller Driver

此代码是在S3C44B0公板上的测试程序，包括boodloader,flash,lcd,common等-This code is in the public board S3C44B0 testing procedures, including boodloader, flash, lcd, common, etc.

This example program shows how to configure and use the A/D Converter of the following microcontrollers: * Philips LPC 2114/2119/2124/2129/2131/2132/2138/2194 After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port. To run this program... 1. Select the Device (Project - Options for Target - Device) 2. Build the project (Project - Build Target) 3. Start the uVision Debugger 4. Open the Serial Window (View - Serial Window 1) 5. Click Run (F5) 6. Click on the Toolbox buttons to change input voltages A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals grap

ARM7启动代码-ARM7 bootcode

sharp arm7 bootloader code