MIPS Assembly Code

ucosII for ARM4510B

WRITTING Nand FLASH Tools

利用easyARM7 2103与OCM4X8中文液晶实现画线，图形化时钟功能。 接线口：P0.5-CS,P0.6-STD,P0.7-SCLK 方式为串行-EasyARM7 2103 with the use of liquid crystal realize OCM4X8 Chinese painting line, graphical clock function. Wiring mouth: P0.5-CS, P0.6-STD, P0.7-SCLK for serial

支持CF存储卡与IDE硬盘的嵌入式文件系统-support CF memory cards with embedded IDE hard disk file system

基于ARM9处理器S3C2410的LCD显示系统设计，选用2410做产品的朋友可以参考-ARM9-based S3C2410 processor, the LCD display system design, selection of 2410 to do the product can refer to a friend

基于ADS1.2+HJTAG+LPC2119的CAN总线调试程序，内带有液晶与按键操作，可根据注释修改。-Based on ADS1.2+ HJTAG+ LPC2119

最新版的基于 Windows CE 的视频捕获解决方案，中微星301视频芯片，在 X86、ARM9、MIPS 等平台上有良好的表现效果，试用版，可持续运行15分钟。-The latest version of Windows CE-based video capture solution, in the MSI 301 video chip, the X86, ARM9, MIPS and other platforms have a good performance results, a trial version, sustainable operation for 15 minutes.

pcf8563时钟操作C语言，可直接在arm，单片机中调用-pcf8563 clock operation of C language, can be directly in the arm, single-chip call

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

tms320c6713的视频图像的采集和显示程序，ccs环境。-tms320c6713 the video image acquisition and display program, ccs environment.