11

一个通过USB->UART读取C8051F060的程序，实现曲线分析、放大、报表等，采用多线程。 驱动从www.silabs.com下载，要用NI的UI控件。完整版。(a USB-)

基于单片机的出租车计价器，其中包括protues图和C++程序(Taxi meter, including protues map and C++ program)

TI 经典的范例 对于学习msp430系列芯片的人肯定有用的 呵呵 可以看看(The classic example of TI msp430 series chips for learning useful Oh man certainly can look at)

这是单片机的一个非常好的一个资料，大家可以参考一下，单片机是个非常有用的入门级的，以后学ARM就非常简单了！学单片机最重要的就是看芯片资料(This is a very good single-chip data, we can refer to the microcontroller is a very useful entry-level, after school ARM is very simple! The most important thing is to learn microcontroller chip information see)

用程控放大器MCP6S26对信号进行增益放大，并用显示屏显示出来。(With a programmable gain amplifier MCP6S26 the signal amplification, and displayed by the display.)

MQ-7烟雾模块 DHT11模块 430单片机驱动 数字量 非模拟量 1602显示(MQ-7 DHT11 430F149 1602)

此程序用于adina粘塑性材料的二次开发，仅仅针对二维。( This procedure is used for the two development of ADINA viscoplastic materials, only for two-dimensional. )

基于Cy7y168013USB接口芯片的逻辑分析仪keil源码(Logic analyzer based on Cy7y168013USB interface chip keil source code)

基于单片机和C语言的，步进电机加速减速匀速演示，希望方便大家(Based on SCM and C language, stepper motor acceleration and deceleration uniform presentation, I hope to facilitate)

交通灯数码管显示4*4键盘修改时间~带仿真图和源代码 模块化编写(Traffic lights digital display 4* 4 keypad to change the time ~ with simulation diagram and source code modular writing)