lpc210x--timer

基于430g2233的温度程序，有18B20和PT1000，两种传感器(The temperature program based on 430g2233)

单片机AD功能实例，使用1602显示电压(SCM AD function example, the use of 1602 shows the voltage)

cc2500的头文件。寄存器的设置使得传输速率为芯片的最大值250kbps，可支持6通道1k的采样率。(cc2500 header file. Register settings for the chip transfer rate makes the maximum 250kbps, can support 6-channel sampling rate of 1k.)

LPC210X 定时器与串口通讯驱动源码(LPC210X timers and serial communication driver source code)

STM32F10系列单片机的IAP程序，实现远程升级(STM32F10 MCU IAP program and remotely upgrade)

TI 官方光伏逆变器学习资料。一个完整的110V纯正弦波输出逆变器学习资料，软硬件都有。(TI Inverter learning resource.)

nRF905接收程序,可与k60连接进行无线通信(RF905 receiving program can communicate wirelessly connect with k60)

说明：  用mcs-52系列单片机实现等精度频率测量，T1引脚接被测TTL信号，晶振22.1184MHz，对任何频率都可以实现很高精度的测量（精度<1 )，结果从串口字符串输出，波特率115200，可以用串口调试器观察结果.(With mcs-52 family of single chip and other precision frequency measurement, T1 pin then measured TTL signal, Crystal 22.1184MHz, any frequency can be achieved very high accuracy of measurement (precision<1 ), the result string from the serial output , baud rate 115200, serial debugger can observe the results.)

通过DS18B20读取温度（范围-55C~125C，精确到小数点后一位），通过4位数码管显示出来。 当温度为正且百位为零时，不显示，当温度为负时百位显负号。当温度百位和十位都为0时0都不显示。(Read through the DS18B20 temperature (range-55C ~ 125C, accurate to one decimal), through four digital tube display. When the temperature is zero and 100, do not show, when the temperature is significantly negative at minus 100. When the temperature is 100 and 10 are not displayed 0:00.)

BOOT引导IAP应用演示程序-目标MCU:MEGA8 晶振:外部(EXT) 8MHZ (BOOT boot IAP application demo program- Target MCU: MEGA8 Crystal: External (EXT) 8MHZ)