uart1

HCS08的AD例程：本程序是ADC模块的例程，所用资源为单片机内部ADC转换模块， 所接器件为电位器.(HCS08 s AD routine: This is the ADC module of the routine procedure, the use of resources within the ADC conversion for the microcontroller module, the device is connected potentiometer.)

随机调制信号下的模拟ppm，基于SVPWM的三电平逆变的matlab仿真，在matlab R2009b调试通过。( Random ppm modulated analog signal under Based on SVPWM three-l)

MPICH安装包，并行处理时的MPI在eclipse中的使用(MPICH installation package, the MPI parallel processing when used in eclipse)

说明：  答题器源码，用51单片机控制的。具体内容自己下载看吧(Answer source browser, with 51 single-chip control. Download and see the specific content of their own)

基于51单片机的信号发生器 四种波形显示 有级调频(Based on 51 single-chip signal generator)

TIF2801的modbus协议程序，带仿真函数(Modbus for TIF2801)

刚才上传的频率计程序可能不太好，现在这个计数外部脉冲的程序，还是较好的，只是得自己从中截取出来(Just upload the program may not be a good frequency counter, and now this external pulse count procedures, or better, just get yourself out from the interception of)

用138,595控制的点阵，附带两个不同控制方式的源程序以及电路连接图，(With 138,595 dot control, with two different control modes of the source and a circuit connection diagram,)

iOS 网络状态监测。网络实时检测，用到Reachability（自行下载）,需加框架:SystemConfiguration.framework ios程序需要用到网络检测，有些程序是刚启动时检测一次，而有些则从头到尾检测网络状态。(IOS network status monitoring.Real-time detection and Reachability (download), frame: SystemConfiguration.framework IOS programs need to use network detection, some detection once when the program is launched, while others detect the network status start to finish.)

单片机初学者资料 51单片机C语言编程入门(详讲版)(Singlechip beginners )