READdht11

利用PID算法控制PWM输出电压，实现串联型数控电源，通过键盘输入控制期望电压(PID algorithm to control the use of PWM output voltage to achieve tandem CNC power, through the keyboard input control voltage expectations)

基于430g2233的温度程序，有18B20和PT1000，两种传感器(The temperature program based on 430g2233)

LCD液晶显示程序，在AT89S52上运行成功，其也可以用于其 他的处理器(LCD liquid crystal display program, run on AT89S52 is successful, it can also be used for the processor)

网络控制单片机proteus仿真 利用网络控制单片机的LED、LCD，我只是整理了一下，方便大家学习，版权归原作者，网页也麻烦站长做好了，有一个上位机，点击自动运行一段程序和打开www.mcufz.com/tcp.htm，之后会自动关闭，有的杀毒软件会报是病毒，放心使用。 开始要安装一个WinPcap软件，不安装它不能仿真，然后运行仿真文件，过一会可以看到LCD显示出了IP地址50。1。1。1 (Proteus simulation network control the use of single-chip microcontroller network control LED, LCD, I am just finishing a bit, to facilitate learning, belongs to original author, the website also do a good job of head trouble, there is a host computer, click Automatic operation for some procedures and open www.mcufz.com/tcp.htm, will automatically shut down after some anti-virus software will be reported to viruses, ease of use. WinPcap started to install a software, do not install it can not simulation, and then run the simulation documents LCD moment we can see the IP addresses shows that 50. 1. 1.1)

STM32F107的单片机，针对红外遥控解码，我们已经使用过(STM32F107 infrared remote control code)

c8051 mcu 单片机 adc程序。全部c8051适用(c8051 adc)

STM32 SPI口的应用例程，可是设置成主模式或者从模式。(STM32 SPI routine application of the mouth, but set to master mode or slave mode.)

刚才上传的频率计程序可能不太好，现在这个计数外部脉冲的程序，还是较好的，只是得自己从中截取出来(Just upload the program may not be a good frequency counter, and now this external pulse count procedures, or better, just get yourself out from the interception of)

IOS端通过蓝牙发送和接收 用的是OC语言，在MACOS上编程(bluetooth sent data and bluetooth received data for IOS)

这是一个基于单片机的LCD显示程序，驱动LCD1602,并显示两条字符。(This is a microcontroller-based LCD display, driver LCD1602, and displays the two characters.)