430g2233

这是一个基于单片机的LCD显示程序，驱动LCD1602,并显示两条字符。(This is a microcontroller-based LCD display, driver LCD1602, and displays the two characters.)

包含位置式PID算法、积分分离式PID，包括广义互相关函数GCC时延估计，真的是一个好程序。( It contains positional PID algorithm, integral separate PID, Including the generalized cross-correlation function GCC time delay estimation, Really is a good program.)

STC51的串口程序，通过STC51工具连接电脑可以用串口助手模拟(STC51 UART)

随机调制信号下的模拟ppm，基于SVPWM的三电平逆变的matlab仿真，在matlab R2009b调试通过。( Random ppm modulated analog signal under Based on SVPWM three-l)

网络控制单片机proteus仿真 利用网络控制单片机的LED、LCD，我只是整理了一下，方便大家学习，版权归原作者，网页也麻烦站长做好了，有一个上位机，点击自动运行一段程序和打开www.mcufz.com/tcp.htm，之后会自动关闭，有的杀毒软件会报是病毒，放心使用。 开始要安装一个WinPcap软件，不安装它不能仿真，然后运行仿真文件，过一会可以看到LCD显示出了IP地址50。1。1。1 (Proteus simulation network control the use of single-chip microcontroller network control LED, LCD, I am just finishing a bit, to facilitate learning, belongs to original author, the website also do a good job of head trouble, there is a host computer, click Automatic operation for some procedures and open www.mcufz.com/tcp.htm, will automatically shut down after some anti-virus software will be reported to viruses, ease of use. WinPcap started to install a software, do not install it can not simulation, and then run the simulation documents LCD moment we can see the IP addresses shows that 50. 1. 1.1)

c8051 mcu 单片机 adc程序。全部c8051适用(c8051 adc)

基于430g2233的温度程序，有18B20和PT1000，两种传感器(The temperature program based on 430g2233)

利用PID算法控制PWM输出电压，实现串联型数控电源，通过键盘输入控制期望电压(PID algorithm to control the use of PWM output voltage to achieve tandem CNC power, through the keyboard input control voltage expectations)

J1939 protocol description

TI 官方光伏逆变器学习资料。一个完整的110V纯正弦波输出逆变器学习资料，软硬件都有。(TI Inverter learning resource.)