FS_FAT32

初学pic mcu c设计，程序功能 按键控制无刷电机(novice pic mcu c design, function keys control of brushless motors)

基于单片机STC89C51和74LS164的多功能数字万用表(Based on microcontroller STC89C51 and 74 ls164 multi-function digital multimeter)

飞思卡尔单片机F56f8037can程序(Freescale microcontroller F56f8037can program)

两轮独立小车编程，已经通过调试，可以站立行走，单片机编程。(Two independent car programming, has been through debugging, you can stand walking, single-chip programming.)

Stock and payment system

Study on LD Pumped Yb3+ -doped Double-clad Fiber Lasers数值分析对线形腔LD泵浦掺镱的双包层光纤激光器进行研究，分析了单端泵浦和双端泵浦的泵浦光及激光输出功率和增益在光纤中的分布，结果表明，非均匀泵浦比较适合高功率光纤激光器。(Study on LD Pumped Yb3+-Doped Double-clad Fiber Lasers numerical analysis of the linear cavity of the LD-pumped Yb-doped double-clad fiber laser research, analysis of single-ended and double-end-pumped pumped pumped optical and laser output power and gain distribution in optical fibers, results show that more suitable for non-uniform-pumped high power fiber lasers.)

C语言编写的pic16f876a单片机程序，用来做电池充放电，调试成功。(The program of C language with pic16f876a microcontroller , used for battery charging and discharging, and has been proved successful.)

STM32 ADC,所用的是神舟开发板，STM32芯片是STM32F107VCT6(STM32 ADC，the STM32 micro core is STM32F107VC)

这是我看了《十天学会单片机》（郭天祥的教程）第十课时写的，综合了矩阵键盘，串口通信，数码管 动态显示，定时器中断的简单时钟程序。用51电子网买的298元80C51单片机学习板 （http://www.51dz.com/n.asp?id=12519&i=xie343706382）测试时请将p1口用排线连到CZ2上，控制8位 数码管用。P0口用来检测矩阵键盘的，P3.0和P3.1是串口通信用，控制74H164N芯片段选8位数码管。 数码管显示内容为时分秒个两位，按下K16为设置按钮，按一下调节秒数，再按一下调节分钟，再按一 下调节小时。再按下退出，走时。调节时按K1至K10分别代表0到9。 我的QQ343706382，希望有喜欢单片机的朋友。和我联系。(This is what I read "10 days Singlechip Society" (郭天祥tutorials) written by the tenth class, integrated matrix keyboard, serial communications, digital tube dynamic display, a simple clock timer interrupt procedures. Electronic network with 51 of 298 yuan to buy 80C51 single-chip learning board (http://www.51dz.com/n.asp?id=12519)

锁相环源程序，基于stm32的控制，开发环境用keil5，(Phase locked loop source program, based on STM32 control, development environment with keil5,)