清达光电液晶驱动192x64，有详细的说明。

atmel at89c51snd1 做mp3的源代码-ATMEL at89c51snd1 do mp3 source code

本程序已经调试通过，使用I2C来从外部时钟芯片中读取并写入时间。文档包含i2c的驱动程序、时钟芯片的读与写、以及使用定时器中断产生脉冲来模拟gps对时。-This procedure has been debugging through the use of I2C chip from the external clock time to read and write. Document contains the i2c driver, the clock read and write chip, and the use of the timer interrupt to simulate the pulse generated when the gps on.

例子Proteus经典例子和中文资料 8051-Examples of classic examples of Proteus and Chinese information 8051

对DS18b20传感器网络编码和搜索,以及对连接线的短路和开路进行检测-right DS18b20 sensor network coding and search, and the link between the short-circuit and open circuit detection

sanDisk sd卡标准协议手册，很好的资料-sanDisk sd card standard protocol manual, very good information

embeded in keil51

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

用MSP430F149仿真SPI接口读写FM25系列铁电的测试程序。包括单字节和多字节读写。已通过测试。请大家放心使用。-with MSP430F149 simulation SPI serial interface to read and write 25 ferroelectric testing procedures. Including single-byte and multi-byte read and write. Have passed the tests. Please rest assured use.

基于PIC18F2580实现的 1602LCD显示程序 只用4个数据口-Based on the PIC18F2580 realize 1602LCD display program only 4 data port

bl55066液晶显示驱动芯片。本程序经过已经使用，本产品我已经开发后投入市场2两年。请大家放心使用。-bl55066 LCD Driver IC. After this procedure has been used, I have developed this product into the market after 2 years. Please rest assured to use.