Terawins的芯片T128点3.5"屏的源程序。

dds 数字频率合成原理仿真程序,下载后，将后缀改为.m即可-dds digital frequency synthesis principle simulation program, download, will be replaced by the suffix. m can

51单片机制作的 密码控制器C程序 适合学习交流-51 MCU password controller C programs produced by the exchange of appropriate learning

提供一个小弟的程序,有点笨,请各位看后,不要见笑.-provide a younger procedures, a bit stupid, you see, not laughed at.

LT_1B msp430开发板例子程序－UART08_096-LT_1B msp430开发板例子程序－UART08_09600

这个程序用于单片机和无线传输芯片CC2500之间的传送，包括发送，驱动，接收等完全的程序-This procedure for single-chip and wireless transmission between the CC2500 chip, including the transmission, drive, receive a complete program, etc.

STC isp应用程序，ISP功能，好东西 S TC isp应用程序，ISP功能，好东西 -STC isp applications, ISP, good things S TC isp applications, ISP, the good stu

该程序是个蜂鸣器的调试程序，歌曲是兰花草-The program is a debug procedures buzzer, songs are兰花草

HX8238 LCD Driver Spec.

P1.7～P1.0接发光二极管L8～L1，要求利用单片机内部定时器1，按方式1工作，每0.01秒T1溢出中断一次。要求编写程序模拟时序控制装置。开机第1秒钟L1、L3亮，第2秒钟L2、L4亮，第3秒钟L5、L7亮，第4秒钟L6、L8亮，第5秒钟L1、L3、L5、L7亮，第6秒钟L2、L4、L6、L8亮，第7秒钟8个发光二极管全亮，……一直循环下去。fosc=11.0592MHz-P1.7- P1.0 then LED L1 to L8, by using a timer internal microcontroller, a work by the way, every 0.01 seconds T1 interrupted an overflow. Simulation prepared timing control device. Boot 1 seconds L1, L3- liang, two seconds L2- L4, L5 three seconds, L7- liang, 4 seconds L6, L8-liang, 5 seconds L1, L2, L5, L7- liang, 6 seconds L2, L4, L6, L8- , 7 seconds 8-LED whole ... has been the cycle continues. 11.0592MHz fosc =

硬件协议栈芯片w3100a的DHCP实现，51单片机，keil51开发环境-hardware stack of chips w3100a DHCP realized, 51 microcontroller, development environment keil51