miniARM embedded web main program, need to run miniarm

基于Verilog下的串口通信实验本实验所实现的功能以及相应的程序思想：验实现的功能有上位机向开发板发送数据，开发板接收以后通过数码管显示，并且将接收到的数据传回给上位机，通过串口调试助手将返回的数据显示出来。

This the gui program for interfacing the computers through matlab.-This is the gui program for interfacing the computers through matlab.

基于凌阳单片机spmc75f2413的步进电机3轴联动空间圆弧插补源程序-Sunplus spmc75f2413 based on single-chip stepper motor of 3-axis circular interpolation space source

44B0的bios文件-44B0 the bios documents

STM32F103定时器TIM2测试及仿真，Keil工程文件。可在调试模式下观察到定时中断产生1ms的方波。

ADC0831驱动程序加上用1602显示。测试成功-ADC0831 driver coupled with the 1602 show. Successfully tested

max531的驱动程序,采用SPI接收方式.经验证,完全正确.-max531 driver using SPI mode receiver. the experience card, absolutely correct.

锂电池 充电保护板 原理图及PCB图 protel99se 格式 珍藏板 已在工程实际用应用-Rechargeable lithium battery protection board and the PCB schematic diagram protel99se collection plate format has been used in engineering applications

MSP430F449与ATT7022开发的一款三相表demo，完善中，其中的几个程序模块，仅供参考。-MSP430F449 with the ATT7022 the development of a three-phase table demo, perfect, where several program modules for reference purposes only.

基于LPC2148的UCOSII移植，带6个任务-UCOSII transplantation based on the LPC2148, with six mission