Up to the software testing software, and provide source code, to the effective i...

我自己用的MSP430的JTAG。包括原理图和PCB版图！AD6软件打开。-my own use MSP430 JTAG. Including schematic and PCB territory! Sp open software.

LPC2148 IIC驱动程序，驱动EEPROM-LPC2148

利用PSOC3的cy8c38做的。能adc转换，同时数据在lcd1602显示。-PSOC3 using the cy8c38 do. To convert data, in adc lcd1602 display.

GE PLC 编程软件 适合所有GE PLC -GE PLC

minigui安装配置（red7.x以上版本）-MiniGUI installation configurations (red7.x versions)

恒温控制器程序，采用双向晶间管通过单片机进行温度可调的一个程序。实时性很强-Temperature controller program, using two-dimensional crystal the temperature between the tube through the MCU adjustable a program. Real-time very

文章描述了TMS320C6000 digital signal processors (DSPs)的CPU结构、管道技术、指令系统. --It describes TMS320C6000 digital signal processors (DSPs) s CPU structure, channel technique and instructions.

Altera recommends the following system configuration: * Pentium II 400 with 512-MB system memory (faster systems give better software performance) * SVGA monitor * CD-ROM drive * One or more of the following I/O ports: - USB port (if using Windows XP or Windows 2000) for USB-Blaster(TM) or MasterBlaster(TM) communications cables, or APU programming unit - Parallel port for ByteBlasterMV(TM) or ByteBlaster(TM) II download cables - Serial port for MasterBlaster communications cable * TCP/IP networking protocol installed * Windows 2000, Windows NT 4.0 with Service Pack 3 or later, or Windows XP * Internet Explorer 5.0 or later Memory & Disk Space Requirements USB开发--Altera recommends the following system configuration:* Pentium II 400 with 512-MB system memory (faster systems give better software performance)* SVGA monitor* CD-ROM drive* One or more of the following I/O ports:- USB port (if using Windows XP or Windows 2000) for USB-Blaster(TM) or MasterBlaster(TM) communications cables, o

步进电机控制系统 ，DOC内有原理图，注释-stepper motor control system, DOC has diagram Notes

ks8695网络处理器资料汇编。-ks8695 network processor compilation.