C51 LCD 显示程序非常具有参考价值

针对MSP430单片机开发的电机控制程序。是一个较详尽和完善的程序。-MSP430 development for single-chip motor control procedures. Is a more detailed and comprehensive procedures.

X5043读写程序，非常少见的可以直接调用的源代码，对你非常有帮助-X5043 to read and write procedures, very rare direct call to the source code, and for your very helpful

利用DS18B20采集温度，显示温度到lcd上-DS18B20 collected using temperature, shows that the temperature on the lcd

315M无线遥控解码程序,最大的问题就是距离，现在只能在100m左右。-315M wireless remote control decoding procedure, the biggest problem is the distance, now only about 100m.

周立功公司开发的单片机手册，具体的数据手册见周立功网站下载。-Week Ligong Singlechip developed manual, the specific data manual see Zhou Ligong website.

该项目是用三态分时扫描法驱动法实行控制12×48个发光二极管的驱动，并实现串口通讯，内附原理图，程序，DATAsheet-The project is using three-state time-scanning method driven control of 12 × 48 LEDs of the drive, and the serial communications, containing schematics, procedures, DATAsheet

本设计采用凌阳16 位单片机SPCE061A对步00进电机进行控制，通过IO口输出的具有时序的方波作为步进电机的控制信号，信号经过芯片L298N驱动步进电机；-This design uses 16-bit single-chip Sunplus SPCE061A to step into the motor control 00, through the IO port with the output timing of the square wave as a stepper motor control signal, the signal after the chip stepper motor driver L298N

用ATMEGA8开发的MMC程式,可用AVR-GCC开发-with ATMEGA8 development of the MMC programs, available AVR-GCC Development

数电\_数字控制系统――原理、硬件与软件-few-- _ digital control system-- including hardware and software

arm7 lpc2132 GPIO driver for beep