该项目是用三态分时扫描法驱动法实行控制12×48个发光二极管的驱动，并实现串口通讯，内附原理图，程序，DATAsheet...

可以用单片机做一个卡-SCM can be used to do a card

这是sd/mmc卡程序地而部分内容，后面还有！-This is the sd/mmc card program and part of the contents in the back there!

这是一个holtek单片机HT47R20_A读写at24c01的子程页，具有分页读写功能。-This is a HOLTEK SCM HT47R20_A literacy at24c01 the son-page tabs with read and write capabilities.

数码时钟显示，用8位LED软件译码动态显示，P0为字段码,P2为位选码，数码管共阳， key0为位选键；key1为加“1键；key2为减“1”键。-Digital clock display with 8 LED dynamic display software decoding, P0 code for the field, P2 election code for the digital, digital tube were positive, key0 bond election for the position key1 to add " 1 button key2 to reduce the" 1 " button.

CC1000为RF芯片，作为无线通信处理芯片，本程序是基于PIC72作为处理器。频段为433.92M，具有多种通信方式，通信速度可达到65K。-CC1000 RF chip, as wireless communications processing chip, the procedure is based on the PIC72 as the processor. For 433.92M band with a variety of means of communication, communication speeds up to 65K.

一个C编的通信程序原代码-a series of the C source code Communication Program

介绍了无线传感器网络的路由协议的研究进展，安全性研究，以及仿真的研究。-Introduced a wireless sensor network routing protocol research, safety research, as well as simulation studies.

实现AD转换tlc549芯片的驱动，建模力量转化为数字量-TLC549 chip AD conversion realize the driving, modeling forces into digital

PIC MCU information 10 to 16 serious

基于单片机准双向I/O的键盘程序基于单片机准双向I/O的键盘程序-Based on single-chip quasi-bidirectional I/O keyboard procedures Singlechip-based quasi-two-way I/O keyboard procedures