登录
首页 » VHDL » LCD例程 altera官方Verilog代码 详尽简单实用

LCD例程 altera官方Verilog代码 详尽简单实用

于 2022-09-20 发布 文件大小:367.75 kB
0 152
下载积分: 2 下载次数: 1

代码说明:

LCD例程 altera官方Verilog代码 详尽简单实用-LCD routines altera official Verilog code is simple and practical details

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 不足20元的PCI设计,含ABEL源代码。
    不足20元的PCI设计,含ABEL源代码。-PCI design less than 20Yuan ,including ABEL code
    2022-01-24 17:08:50下载
    积分:1
  • verilog digital stopwatch to achieve accurate to 10ms
    verilog实现的数字跑表 精确到10ms-verilog digital stopwatch to achieve accurate to 10ms
    2022-04-18 11:51:54下载
    积分:1
  • emif_tt
    实现dsp与fpga的emif的verilog异步实现,可实现异步读写以及相应功能模块控制,文件中包含仿真后的波形图形以及仿真测试程序,运行环境quartus ii11.0,仿真环境mmodelsim se 6.5d(Achieve dsp and fpga verilog asynchronous implementation of the emif, enabling asynchronous reading and writing as well as the corresponding function module control, the document contains graphics, and after the simulation waveform simulation testing procedures, operating environment quartus ii11.0, simulation environment mmodelsim se 6.5d)
    2020-12-04 15:59:23下载
    积分:1
  • S05_example_Network
    说明:  vivado lwip 应用文档 基于zynq 7020(vivado lwip example text of zynq)
    2020-06-17 11:40:02下载
    积分:1
  • FPGA
    学习FPGA的资料,基于FPGA的卡尔曼滤波器的设计与实现(Learning FPGA information, FPGA-based Design and Implementation of Kalman Filter)
    2010-03-15 21:19:56下载
    积分:1
  • nIOS_VGA
    用NIOSII生成的VGA显示程序,可以在显示器上显示通讯内容
    2009-10-12 20:58:00下载
    积分:1
  • 有限状态机 — FSM
    有限状态机是指输出取决于过去输入部分和当前输入部分是时序逻辑电路。在有限状态机中,状态寄存器的下一个状态不仅与输入信号有关,而且还与该寄存器的当前输入有关,因此有限状态机又可以认为是组合逻辑和寄存器逻辑的一中组合。下面代码是哈工大计算机学院CPU设计中关于有限状态机部分的代码。
    2022-07-18 13:01:32下载
    积分:1
  • adc0809
    1、用状态机设计A/D转换器ADC0809的采样控制电路,并在数码管上显示转换结果; 2、设置有复位和启动/保持开关,要求 ⑴ 复位开关用来使A/D转换器复位,并做好A/D转换准备; ⑵ 启动/保持开关用来控制A/D转换器开始连续转换或停止转换保持结果,即按一下启动/保持开关,启动A/D转换器开始转换,再按一下启/停开关,停止转换并保持结果。 3、采用Verilog HDL语言设计符合上述功能要求的控制电路。(1, with the state machine design A/D converter ADC0809 sampling control circuit and display the results on the digital conversion 2 is provided with a reset and start/hold switch, reset switch is used to make the request ⑴ A/D converter reset and do A/D conversion ready ⑵ start/hold switch is used to control the A/D converter starts converting or stop the conversion to maintain a continuous result that by clicking Start/hold switch, start the A/D converter to start the conversion, and then Click the start/stop switch stops the conversion and keep the results. 3, using Verilog HDL language designed to meet the functional requirements of the above-mentioned control circuit.)
    2021-01-02 21:38:57下载
    积分:1
  • MSK_BER
    msk比特误码率matlab仿真 匹配滤波器(the msk bit error rate matlab simulation matched filter)
    2020-11-14 11:49:42下载
    积分:1
  • 4ASKmod2
    讲述4ASK的原理并附有matlab调制解调的源码。。。。。。。。。。 注:原来上传的4ASKmod.zip不要下(The principle tells 4ASK together with modulation and demodulation matlab source. . . . . . . . . . Note: The original upload 4ASKmod.zip not down)
    2013-07-10 00:01:10下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载