c51primer

一个在89c52单片机上实现的多路温度采集通信程序-A 89c52 single-chip to achieve the multi-channel temperature acquisition Communication Program

震动强度的测量 ad转换 八段数码管显示 51单片机-ad leddisplay

STC89C58RD+的内部EEPROM读写程序-STC89C58RD+ Internal EEPROM read and write procedures

C8051F040 UART0模式1全双工通信 uart0模式1主机程序-C8051F040 UART0 a full-duplex mode of communication uart0 a mainframe model procedures

can_bus_protocol_2.0b CAN总线协议-can_bus_protocol_2.0b CAN bus protocol

这是一个在proteus下仿真成功的闪烁灯的例子。对于初级学习proteus的人很有帮助-This is a simulation in proteus success under the lights flicker example. For the initial study and the people very helpful proteus

本文主要介绍ARM JTAG调试的基本原理，基本内容包括了TAP 和BOUNDARY-SCAN ARCHITECTURE的介绍。在此基础上，结合ARM7TDMI详细介绍了JTAG的调试原理。-This paper describes the basic principles of ARM JTAG debugger, the basic elements including TAP and BOUNDARY-SCAN ARCHITECTURE introduction. On this basis, combined with detailed information on ARM7TDMI principles of JTAG debugging.

在51单片机系统中利用专用以太网控制芯片RTL8019AS实现以太网接口-51 single-chip microcomputer system in the use of a dedicated control chip RTL8019AS Ethernet Ethernet interface

ADuC845中关于TIC功能的使用所写的小程序-ADuC845 features on the use of TIC small programs written by

一个320*240的液晶的C51驱动，程序不光可以用在51单片机上，还可以应用在其他单片机上，已成功移植到MSP430，移植时只需要重新改下引脚定义-A 320* 240 LCD drive the C51, the program not only can be used in single-chip microcomputer 51, but also can be applied to other single-chip, this has been successfully transplanted into MSP430, transplantation need to change only the definition of under-pin