CAN总线的应用

基于51单片机的I2C通信程序，可以顺利实现I2C通信-Based on 51 MCU I2C communication program can be successfully I2C communication

简单的示波器程序，大家可以学学里面的设计思想，这是别人开发的 哦-Oscilloscopes simple procedures, which everyone can learn the design idea, which is developed by someone else, oh

利用NXP的新一代高集成度的芯片RC500完成Mifare系列卡的读写-The use of a new generation of highly integrated NXP" s Mifare chip RC500 Series completion card reader

GZ60的can通信源程序 用c语言编写-can GZ60 of communication with the source language c

此为锁相环函数发生器 包括键盘扫描程序 频率显示程序 波形显示程序-This is the phase-locked function generators including the keyboard scanner frequency waveform display shows process procedures, etc.

传感器应用实例电路设计150例，资源共享，敬请使用！-Sensor circuit design application 150 cases, resource sharing, please use!

单片机中的定时器模块，在CVAVR中已实现。-MCU timer module has been achieved in CVAVR.

Tea5767的3线控制程序，M8单片机，采用3线控制，内有电路原理图，可手动指定频率，也可以上下搜索-TEA5767 the 3-wire control procedures, M8 MCU, using 3-wire control with a circuit schematic can be manually specified frequency, can also be upper and lower search

在单片机系统中实现4*4的小键盘的扫描程序，按键输出对应信号，可以根据按键来设定输出对应高低电平-Single-chip microcomputer system in the implementation of the 4* 4 keypad scanning procedures, the corresponding button output signal can be output in accordance with the corresponding button to set the high-low

红外通信是利用950nm近红外波段的红外线作为传递信息的媒体，即通信信道。发送端采用脉时调制（PPM）方式，将二进制数字信号调制成某一频率的脉冲序列，并驱动红外发射管以光脉冲的形式发送出去；接收端将接收到的光脉转换成电信号，再经过放大、滤波等处理后送给解调电路进行解调，还原为二进制数字信号后输出。-Infrared communication is the use of near infrared 950nm infra-red as the transmission of information media, namely communication channel. The sending end when the use of pulse modulation (PPM) approach will be a binary digital signal into a frequency modulation of the pulse sequence, and driver fired infrared tube to the form of light pulses sent receiver will receive the pulse of light conversion to electrical signals , and then, after amplification, filtering and other treatment to the demodulation circuit after demodulation, reduced to a binary digital signal after the output.