TLC5615 DA转换器驱动程序（KEIL）

cw环境下例子程！ DS18B20实验 用户成功安装好CW6.0后，双击每个实验文件夹下的.mcp文件即可。 注：用户如果安装其他CW软件，一定要确保.mcp文件打开方式为CW6.0.-cw example environment-way! DS18B20 experimental CW6.0 successfully installed, double-click each folder under the experiment. Mcp files. Note: If users install additional software CW, we must ensure that. Mcp file open for CW6.0.

开发硬件电路需要用到液晶显示模块1602的用户必备。调试实验源程序第四部分。-Hardware needed to develop liquid crystal display module 1602 required the user. The fourth part of the experimental source code debugging.

八路模拟采集显示电路　可对模拟信号进行采集　并用数码管显示-Eight-way acquisition display circuit simulation can be carried out on the analog signal acquisition and digital display

利用MEGA8同时控制四路分立的单总线设备TH-11数字湿温度传感器，并根据查找表反推出传感器电阻值，显示在LCD12864显示器上。公司内部用机器。-MEGA8 simultaneously control the use of four separate single-bus devices TH-11 digital wet temperature sensor and, based on look-up table against introduction of sensor resistance value, displayed in the LCD12864 display. Within the company with the test machine.

用SST89C58,对微型打印机和液晶的显示-With SST89C58, on the micro-printer and liquid crystal display

x5045的相关程序，可以在keil c 上运行-X5045 procedures, you can run keil c

USB转lpt 68013 驱动方案 USB转lpt 68013 驱动方案-Lpt 68013 Driver USB to USB transfer program lpt 68013 driver program

在单片机编程中位图及字库点阵提取程序源代码- The position chart and the fonts lattice withdraw the procedure source code in the monolithic integrated circuit programming

这是一个单片机上实现T9输入法的程序，使用C语言编写。-This is a single-chip realization of the T9 input method of procedure, the use of C language.

CAN 驱动程序 源码 经军DEVICENET的前提！-CAN driver source code as a prerequisite for military DeviceNET!