TONG GUO TONG GUOT

这是介绍凌阳单片机基础的PPT教案！要是有学凌阳的可以好好看看它哦，个人感觉还不错！-This is the introduction Singlechip Sunplus based PPT lesson plans! If the school has Sunplus can look at it, oh well, personal feeling pretty good!

这是一个基于c8051F060的示波器程序，开发软件为keil。希望给这方面研究的朋友提供一些帮助。-This is a c8051F060 Based on the oscilloscope procedures, to develop software for keil. I hope to study this area with some friends to help.

单片机是52的，P0口连到四个数码管的七个管脚，其中两个冒号点为最后两个数码管的DOP点，P1.0至P1.3为四个数码管的选通端，低电平有效。程序2较完整，可实现设定时间功能。-Singlechip is 52, P0 port connected to four of the seven-pin digital tube, two of which point to the last two colon tube DOP-point digital, P1.0 to P1.3 for the election of four digital tube pass-side, active-low. 2 a more complete procedure, set the time function can be realized.

本文档包括单片机系统中常用到的时钟中断、通讯及键盘扫描等模块(见所附源程序)的说明。这些模块使用前后台系统模型。为达到最大的灵活性, 需要在用户工程中定义config.h文件, 在其中定义各模块可选参数的设置，而不是直接更改源代码。-this document, including SCM system clock used to the interruption communications and keyboard scanning modules (see accompanying source code) Note. These modules use before and after the Taiwan model. To achieve maximum flexibility in user defined config.h engineering documents, in the definition module optional parameter settings, and not to directly change the source code.

FAT12/FAT16/FAT32/NTFS specification

AVR单片机开发EEPROM读写实验源程序-AVR single-chip EEPROM read and write to develop the experimental source

实现三线控制LCD1602，并附有相关c程序，是一电子设计模块，在减少使用接口方面非常实用-The realization of three-wire control LCD1602, with c-related procedures, is a electronic design modules, to reduce the use of interfaces in a very practical

凌阳单片机实现时钟并语音报时的源代码 很有趣 当毕业设计不错

液晶19264驱动程序。显示一串字符。用AT8515L控制，经过调试成功-19,264 LCD driver. Showed a bunch of characters. With AT8515L control, after successful testing

采用普通单片机控制的电桥测试仪，贡献给大家啊-Ordinary single-chip microcomputer-controlled electric bridge tester, contribution to the U.S. ah