AVR单片机开发EEPROM读写实验源程序

avr rtos AVR单片机上的实时操作系统-avr Byelorussian AVR on the real-time operating system

用于51系列的高精度的实用延时程序，是编程的很好参考资料。-51 for a series of high-precision delay practical procedures, programming is a good reference.

CAN控制器SJA1000的标准帧，BsaicCAN模式，调好的初始化、发送、接收底层程序，大家共享。-CAN controller SJA1000 standard frame, BsaicCAN mode, tune good initialization, send, receive the bottom of procedures, for all to share.

这是一个键盘扫描的程序，相信想做毕业设计的同学非常想得到的哦，想要就看看吧，不好的话多提建议哦-This is a keyboard scanning procedures, wanted to believe that the students graduate design is the kind of oh, want to see it on, the poor more suggestions oh

430 1611 的PDF，一片功能丰富实用的单片机-4,301,611 of the PDF, a feature-rich and practical single-chip microcomputer

4510开发板bios源码 (强烈推荐).zip-4510 development board bios source (strongly recommended). Zip

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

VHDL编写的八位9值信号的中值输出方法，特点是不采用流水或状态机设计，因此速度较快-VHDL prepared by eight of the nine value signal output value method, which is characterized by not using water or state machine design, therefore faster

用SST89C58,对微型打印机和液晶的显示-With SST89C58, on the micro-printer and liquid crystal display

本文档是翻译后的ATMEL的8bit单片机atmega16l的中文数据手册，供参考-this document is the chinese spec of atmega16l