19,264 LCD driver. Showed a bunch of characters. With AT8515L control, after suc...

ds1302.rar驱动程序,已经通过测试.-ds1302.rar driver has passed the test.

这个范例说明如何使用8051 的Port 1连接到四颗七段显示器，PORT 0的低4位分别控制这四颗共阳七段显示器，让四颗共阳七段显示器使用扫描的方式轮流-This example shows how to use the 8051 Port 1 connected to four seven-segment display, PORT 0, low 4, respectively to control the total of four seven-segment display yang, so that a total of four seven-segment display yang way of using the scan rotation

串口双工通讯，单片机上用LCD显示主机发送的数据，同时可以通过单片机的按键向主机发送多种数据-Duplex serial communication, single-chip LCD display with a host to send data at the same time can be key to the host MCU to send multiple data

LT_1B msp430开发板例子程序－UART11_0115k_2

用单片机实现(载波监听/冲突检测)的功能，用的是MSP430芯片来实现。分为主机和从机两个程序-a c language for mcu.

这是用PIC芯片处理USB的源代码,包括初始化USB，中断设置等，是汇编语言入门USB操作的很好参考程序！-This is the PIC chip USB source code, including the USB initialization, interrupt settings, assembly language entry USB good reference operating procedure!

芯片PCF8951共有四个A/D输入通道：AD0，AD1，AD2，AD3,分别与四个电位器(R1,R2,R3,R4)连接，用以调节电位器的输出电压。其中AD0通道既可测量电位器输出电压，也可用于测量从J1插座输入的外接电压，须用开关J2加以选择。J4插座提供由PCF8591输出的时钟方波信号。SAA1064驱动四个数码管显示一路AD转换后得到的数据。-PCF8951 chip, there are four A/D input channels: AD0, AD1, AD2, AD3, respectively, with four potentiometers (R1, R2, R3, R4) connected to regulate the output voltage potential. AD0 channel which can be measured potentiometer output voltage can also be used to measure the input from the J1 socket external voltage, to be used to select switch J2. J4 socket output from the PCF8591 clock square wave signal. SAA1064 drivers of four digital display along after AD conversion data.

RS232串口程序，波特率可自行设置，如9600，19200，接收和发送程序-RS232 serial procedures, its own baud rate settings, such as 9600,19200, receive and send program

基于51单片机的简单LED显示程序，供学习使用-51 single-chip based on a simple LED display program for learning to use

基于51的动态内存管理-dynamic memory management