凌阳单片机实现时钟并语音报时的源代码 很有趣 当毕业设计不错...

128*64程序和仿真80C51 128*64 LCM program and simulate for 80C51. help for you -128* 64 procedures and simulation 80C51128* 64 LCM program and simulate for 80C51.help for you

keil uVision3编译环境，51程序。-keil uVision3 build environment, 51 program.

KEIL中有关电子时钟的源程序，可以在KEIL中模拟实现电子时钟-KEIL in the electronic clock source, you can simulate KEIL realize electronic clock

avr单片机atmega16，用键盘控制，可显示多种不同的跑马灯程序-avr microcontroller atmega16, keyboard control, can display a wide variety of marquees program

24c16的C51源代码,在KEIL C51上已调试通过-24c16 source of C51, C51 has KEIL through debugging

非常好用的串行数据转并行数据的芯片,价格也不高,非常好用,程序经过调试,可用-very good for serial data transfer data in parallel to the chip, the price is not high, very handy, procedures after debugging, available

单片机控制继电器的自动化调试系统，很详细的描述。-MCU Control Relay automated debugging systems, it is described in detail.

avr Led test program in c

使用W77e58读写PCF8563时钟芯片，包含所有的子函数，均可以直接使用。-Use W77e58 literacy PCF8563 clock chip that contains all of the subroutine, can be used directly.

由8051组成的单片机系统通常情况下，P0口分时复用作为地址、数据总线，P2口提供A15-A8即高8位地址，P3口用作第二功能，只有P1口通常用作I/0口。P1口是8位准双向口，它的每一位都可独立地定义为输入或输出，因此既可作为8位的并行I/O口，也可作为8位的输入输出端。当工作在输入方式时，对应位的锁存器必须先置1,才能正确地读到引脚上的信号,否则,执行读引脚指令时,若对应位的锁存器的值为0，读的结果永远为0。-By 8051, composed of single-chip microcomputer system under normal circumstances, P0 timeshare I reuse as address, data bus, P2 I provide A15-A8 high eight address, P3 mouth for the second function, I usually only P1 for I/0 I. P1 I was eight quasi-two-way port, it can be independent of each and every defined as input or output, it can be used as 8-bit parallel I/O port, can also be used as 8-bit input and output side. When the work in the input, the corresponding bit latch must first buy one in order to correctly read the signal pin, or pin the implementation of reading instruction, if the corresponding bit latch the value of 0, Reading the results of Forever to 0.