51单片机控制dm413 R,G,B色彩变化。

8051单片机驱动1602字符液晶的C驱动 已经调试成功，移植性非常好，并且加入了大量注释，这个源码事我成功修改的，绝对可以用-8051 LCD Driver 1602 characters debug the C drive has been successful, transplantation is very good, and adding a lot of notes, the source of issues which I have successfully modified, and absolutely can be used

跑马灯程序,单片机初学者入门毕用的程序,里面代码已运行过,无误.-Marquee procedures Singlechip beginners used to complete entry procedures, which the code has been in operation, and correct.

用于两单片机利用串口通信。有完整的原理图、仿真、程序。-For the use of two single-chip serial communication. A complete schematic, simulation, process.

通过PIC单片机控制CC00通信，按某一个键在八段LED上显示相应的键值-Through the PIC SCM CC00 communications, according to a key in the eight LED display the corresponding key

这是凌阳61板的原理图和PCB版图，希望能给大家的学习提供帮助！-This is the Sunplus 61 board schematic and PCB layout, hope that I can help everyone to learn!

单片机的编译环境 功能齐全，操作简单，适合初学者使用-SCM build environment fully functional, simple operation, for beginners

用汇编语言编写的超声波测距控制源程序采用AT89S51,12ＭＨz晶振 -Prepared by using assembly language source code control using ultrasonic ranging AT89S51, 12MHz crystal

430单片机和DS1302的程序。验证通过，直接调用函数使用。-430/ds1302

本程序运行于C8051F330，功能为接收遥控器发出的红外信号，然后等待上位机通过I2C总线来读取。IR数据接收完毕后，不再采集新的IR数据，一直等待上位机将数据取走后才开始准备接收新的IR数据-this program running on the C8051F330, functional remote control device to receive the infrared signal, Then wait for the PC through the I2C bus to read. IR data receiving end, not the acquisition of new IR data have been waiting for the PC will be removed after data began preparing to receive the new IR data

C8051F040单片机CAN总线接收和发射程序，简单明了-C8051F040 single-chip CAN-bus to receive and launch procedures, simple