登录
首页 » SCM » AD0809 在51 单片机中的应用.pdf

AD0809 在51 单片机中的应用.pdf

于 2022-01-26 发布 文件大小:89.19 kB
0 182
下载积分: 2 下载次数: 1

代码说明:

AD0809 在51 单片机中的应用.pdf-AD0809 in 51 MCU. Pdf

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 单片机数字显示程序,含头文件,说明,本人亲自试过.
    单片机数字显示程序,含头文件,说明,本人亲自试过.-Single-chip digital display program, including the first document, I personally tried.
    2023-06-14 10:20:03下载
    积分:1
  • 一段键盘处理源码,包括按键处理、AD采样等功能。
    一段键盘处理源码,包括按键处理、AD采样等功能。-Section of the keyboard handle source, including the key treatment, AD sampling and other functions.
    2022-02-13 02:00:39下载
    积分:1
  • VB6.0小程序控制单片机P1口8位LED.很好用的
    VB6.0小程序控制单片机P1口8位LED.很好用的-VB6.0 small program P1 mouth Singlechip 8 LED. Well used
    2023-02-21 11:30:03下载
    积分:1
  • Realize the full RS232 and TCP/IP network protocol conversion
    完整的实现RS232与TCP/IP网络协议的转换-Realize the full RS232 and TCP/IP network protocol conversion
    2022-03-16 02:52:26下载
    积分:1
  • 用于驱动24L01芯片的函数代码,老外写的,很漂亮!
    用于驱动24L01芯片的函数代码,老外写的,很漂亮!-24L01 chip used to drive the function code, written by a foreigner, very beautiful!
    2022-03-24 08:44:29下载
    积分:1
  • of motor speed control procedures, you can use this procedure to set parameters,...
    电机调速的控制程序,你可以通过这个程序来设定参数,通过反馈就可以控制速度了啊!-of motor speed control procedures, you can use this procedure to set parameters, feedback can control the pace of their ah!
    2022-03-26 15:00:55下载
    积分:1
  • 基于Freescale
    基于Freescale-smac的点对点通讯。 简介:在Router(特征:接口为COM口)上实现点对点通信。 子工程: 1、接收端receiver_13213_ver2.0 (目前只写了接收端部分,我打算用已经调试好的13213-NCB 作为发送端,如果测试通过,我会写与它配套的发送端程序) 功能详述: 1、发送端与接收端上电后均为DS2点亮; 2、发送端启动以后,大约每1s发送一个数据包"ABCD",每次发送时 DS3点亮,并持续0.5s 3、接收端收到信号后,DS3将点亮,持续0.25s 4、所以总的效果是:两块板子启动以后均为DS2点亮,发送端的DS3 以1s左右为周期闪烁,灯亮的时间为0.5s;接收端的板子DS3随着发 送端的DS3闪烁,周期也为1s,但灯亮的时间为0.25s。 试验的时候,如果看到接收端的DS3在不停的闪,那么说明两块板子 能实现点对点通信。 备注:该工程的两个文件夹transmitter_13213_ver2.0、receiver_13213_ver2.0 要放到FreescaleSMAC4.2S08apps 目录下才能正常编译、连接, 否则可能报错。-err
    2022-02-14 23:34:19下载
    积分:1
  • 温度测量程序,包括显示、数据采集、进位、延时、数摸转换...
    温度测量程序,包括显示、数据采集、进位、延时、数摸转换-temperature measurement procedures, including display, data acquisition, rounding, delay, a few touch conversion, etc.
    2022-05-24 23:12:05下载
    积分:1
  • 密码锁:根据设定好的密码,采用二个按键实现密码的输入功能,当密码输入正确之后,锁就打开,如果输入的三次的密码不正确,就锁定按键3秒钟,同时发现报警声,直到没有按...
    密码锁:根据设定好的密码,采用二个按键实现密码的输入功能,当密码输入正确之后,锁就打开,如果输入的三次的密码不正确,就锁定按键3秒钟,同时发现报警声,直到没有按键按下3种后,才打开按键锁定功能;否则在3秒钟内仍有按键按下,就重新锁定按键3秒时间并报警-Password Lock: According to set a good password, the password used to achieve two key input function, when to enter the correct password, the lock will open, if entered incorrect password three times, on the lock button 3 seconds, also found that alarm sound, do not press the button until the three kinds of after the Open button lock function otherwise, there is still a matter of seconds in the 3 button press, on the re-lock button 3 seconds time and alarm
    2023-08-06 08:35:04下载
    积分:1
  • 基于51单片机的I2C通信程序,可以顺利实现I2C通信
    基于51单片机的I2C通信程序,可以顺利实现I2C通信-Based on 51 MCU I2C communication program can be successfully I2C communication
    2023-04-14 17:40:03下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载