USB source code, including the PC client and single

MSP430F2350 I2C Library

用过采样和求均值技术提高模数转换器的分辨率.pdf-----针对目前单片机内嵌的模／数转换器的分辨率太低，而外接高分辨率成本又太高的情况，提出了用“过采样和求均值”的技术来使在有用的测量频带内的信噪比得到改善，从而提高测量的分辨. 率。并利用 60 - 7 0 /对其结论进行仿真，且在单片机上予以实现，结果表明测量分辨率明显提高。-Sampling and averaging techniques used to improve the resolution of ADC. Pdf----- targeted at the embedded microcontroller A/D converter resolution is too low, while the external high-resolution costs are too high situation, put forward with " Oversampling and Averaging" technology to make useful measurements in the frequency band signal to noise ratio to be improved, thereby enhancing the measurement resolution. rate. And a 60- 7 0/simulation of its conclusions, and in the SCM to be achieved, results show that the measurement resolution has improved significantly.

非常好用的CH375串口转USB口程序.可以方便的实现,用USB通讯,和做为主机- code usb

c8051f020单片机lcd驱动编程-C8051F020 Singlechip lcd-driven programming

采用STC89C54RD实现的一个完整的流量计控制系统源代码，包含了对STC89C54RD内部Flash的编程（自创）和对ICL7135的数据采集编程，该代码实现的产品已经实用化。-STC89C54RD used to achieve a complete flowmeter control system source code, contains an internal Flash programming STC89C54RD (own) and ICL7135 data acquisition programming, the code of the product has been the realization of practical use.

基于飞利浦 lpc2104 arm7 微处理器的部分程序-Microprocessor-based Philips lpc2104 arm7 Part of the procedure

本文只有程序，无电路图，是基于单片机控制的线性数字稳压电源-In this paper, only the procedures, no circuit diagram is based on the number of single-chip control of linear regulated power supply

2个F040之间的CAN通讯，可以远程帧收发，c语言-2 of the CAN communication between the F040, you can send and receive remote frames, c language

2048点FFT在TMS320C240x定点DSP上的实现2048点FFT在TMS320C240x定点DSP上的实现-2048-point FFT in TMS320C240x fixed-point DSP to achieve the 2,048 points FF T in TMS320C240x fixed-point DSP Implementation

51单片机的编程规范，对初学51编程有帮助。-51 microcontroller programming norms for beginners 51 programming help.