msp430f169的ad da程序，很有用的，一定要看啊

51通讯程序， 读串口并显示累加，调试基本通过-51 communication procedure, reads the string mouth and the demonstration accumulates, the debugging basically passes

A/转换程序，用在8051或8031，此外还有两个小的显示的程序-A/switching procedures used in 8051 or 8031, in addition to two small display procedures

HT24 系列的EEPROM 总共8 个管脚，三个为芯片地址脚A0、A1、A2，在单片机对它进行操作时，从SDA 输入A0、A1、A2 数据和芯片外部A0、A1、A2 所接地址需一一对应。一个为芯片写保护脚WP，WP 脚接低电平时，芯片可进行读写操作；WP 脚接高时，芯片只可进行读，不可进行写。 另外两个管脚为电源脚VCC，VSS。 用单片机对HT24 系列的EEPROM 进行控制时，HT24 系列的EEPROM 的外部管脚VCC、VSS、WP、A0、A1、A2 根据需要，对应接上，SDA、SCL 接到单片机控制脚上。-HT24 Series EEPROM total of 8 pins, three pins for the chip address A0, A1, A2, in the microcontroller to operate it, from SDA input A0, A1, A2, and chip external data A0, A1, A2 of the Then one correspondence address must be in. One for the chip, write-protect pin WP, WP feet then low, the chip can be read and write operations WP pin is high then, the chip can only be read, not write. The other two pins for the power pin VCC, VSS. With the microcontroller on the HT24 Series EEPROM control when, HT24 Series EEPROM external pin VCC, VSS, WP, A0, A1, A2 according to the needs of the corresponding connected, SDA, SCL receives SCM control feet .

使用主模式I2C向CAT24WC02写入10字节数据，然后读出校验，若校验通过则BEE发声，否则不断BEE。 基于ADS1.2-use the main mode I2C CAT24WC02 to write 10 bytes of data, and then read out the check, if the check is through BEE audible, constantly BEE. Based on ADS1.2

1602LCM的单片机操作例程和使用手册。-1602LCM microcontroller operation and use of manual routines.

由ADC0809的IN0输入一模拟电压，经过A/D转换后，在三位数码管上显示转换后的数字量-IN0 input from one of the ADC0809 analog voltage, after A/D conversion, in the three digital tube display digital converted

a flight control description with mikrocontroler and DC motors

通讯误码仪测试软件-communications software error Test

香港科大机器人资料 单片机相关知识，开发平台多样-HKUST Information Singlechip robot-related knowledge, development platform for diverse