一个用AVR单片机做的冲电器程序，内包含详细的主程序和头文件。...

单片机开发，通过1302 18b20 1602液晶显示器，实现闹钟的功能-Single-chip development, through the 1302 18b20 1602 LCD, the realization of an alarm clock function

帮朋友写的一个用MCS-51的IO口模拟PWM使外接LED亮度渐变的程序，虽然程序小，不过注释清楚，并已调试OK。-written for a friend with a MCS-51 simulation of the IO mouth so that external PWM LED brightness gradual process Although procedures for small, but clearly Notes, and debugging OK.

单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。 编程使波形信号输出电路输出正弦波信号，并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10，共11个等级。 -Singlechip P1 I connect with the four buttons for the signal amplitude and frequency adjustment operation keys. Singlechip P0, P2.7, P3.6 (-WR) and DA0832, 2 months 741 (operational amplifier) to connect constitute waveform signal output circuit. Programming so that waveform signal output circuit output sine wave signal, and can be operated keys adjust the signal amplitude and frequency. Amplitude and frequency adjustment level from 0 ~ 10, a total of 11 grades.

此源代码为UC/OS-II移植到51单片机的源代码.包括OS_CPU.H,OS_CPU_C.C,OS_CPU_A.S三个主要文件-this source code for the UC/OS-II transplants to 51 SCM source code. Including OS_CPU.H, OS_CPU_C.C, OS_CPU_A.S three key documents

无线模块2401收发,包含：18B20温度检测；串口通信1；数码管_键盘；AD-The wireless transceiver module 2401, including: 18B20 temperature detection serial communication 1 digital tube _ keyboard AD, etc.

Atmega128L的说明，对使用该单片机开发的人员会有很打帮助-Atmega128L note on the use of the single-chip development to help staff there will be a hit

基于51单片机的温度和电压采集与循环显示的控制程序，其中温度传感器为LMA95，采用I2C总线传输，显示器为8段LED数码管-51 single-chip-based temperature and voltage of the cycle of acquisition and display of the control procedures, including temperature sensors for LMA95, using I2C bus transmission, display for the 8 LED digital tube

1543芯片的AD转换C51程序，TLC1543是11通到10位AD芯片-1543 AD converter chip C51 procedures TLC1543 is 11- to 10 AD chip

430成都技术培训会代码，使用IAR-4.10打开。-430 technical training in Chengdu will be the code, the use of IAR-4.10 open.

18b20的仿真实例，希望能帮做一些初学者，-18b20 the simulation example, I hope to do something to help beginners,