ok!The program is very good!

这是JHD19264液晶显示器的驱动源程序，单片机采用的是AT89C52.-LCD driver source, the microcontroller is AT89C52.

基于飞思卡尔16位单片机的的串行通信SCI程序-SCI code

51单片机的按键程序，汇编编写，适合初学者-51 Single-chip key procedures, the compilation of the preparation, suitable for beginners

利用单片机实现的控制电梯系统，参考2004年湖北省大学生电子设计竞赛原题设计。-Realize the use of single-chip control of elevator systems, a reference in 2004 in Hubei Province Undergraduate Electronic Design Contest Design the original title.

这是关于上臂袖带式电子血压计的单片机处理程序，仅供大家参考-This is on the upper arm cuff blood pressure monitor microcontroller electronic treatment procedures, for your reference

周立功LM3S8962开发板提供的 SYSTICK 例程-Week Ligong LM3S8962 development board provided SYSTICK routines

锯齿波信号发生器 函数信号源采用数字存储方式存储一到几个周期，再用时间计数，循环执行的方法实现函数信号的连续输出 -Sawtooth signal generator function signal source using a digital storage means to store some cycle, then the time counting, the method of implementation cycle of the implementation of the continuous output function signals

Proteus仿真实例，在Proteus下仿真uart，非常不错，值得下载。-Proteus simulation example, in the Proteus simulation under the uart, very good, it is worth downloading.

使用主模式I2C向CAT24WC02写入10字节数据，然后读出校验，若校验通过则BEE发声，否则不断BEE。 基于ADS1.2-use the main mode I2C CAT24WC02 to write 10 bytes of data, and then read out the check, if the check is through BEE audible, constantly BEE. Based on ADS1.2

单片机的程序，关笑喇叭报警用的，大家过来看看啊，说不定有用。-SCM procedures, customs police used loudspeakers laugh, we had来看看啊might be useful.