upsd3200_adc.c upsd3200_lcd.c upsd3200 _pwm.c upsd3200_timer.c uPSD practical pr...

C语言写的单片机数字时钟程序，经调试通过-C language to write the single-chip digital clock procedures, adopted by the debug

（个人原创）这个是我在Keil下写的MAX5532--MAX5535通用的驱动代码，由于我编写的时候，考虑到通用性，所以当你使用的时候，需要根据你的器件特性几乎不用修改函数提来调用我的函数模块（我在需要调用的注释和注意点已经写的很清楚了），缩短你的工程开发周期。-(Personal original) This is what I wrote in under Keil GM MAX5532 MAX5535 driver code, as I am prepared when taking into account the general, so when you use when you need to almost do not modify the device characteristics mentioned function to call I have a function module (I need to call attention to the comments and points have been written very clearly), and shorten your project development cycle.

该代码是在凌阳单片机上实现Tcp/IP协议的代码。通过它可以让单片机接入互联网。-the code is in Sunplus SCM achieve TCP/IP protocol code. Through its SCM can allow access to the Internet.

基于ATMEGA128控制的DS18B20的温度显示，采用LED显示。-ATMEGA128-based control DS18B20 the temperature display, LED display.

MCS-51智能反编译器。可将51单片机的bin或hex文件反编译为汇编码。仅用于学习用途，否则后果自负。-MCS-51 Intelligent compiler. May 51 SCM bin hex or documents compiled for the Department of Anti-coding. For learning purposes only, otherwise the consequences conceited.

USB驱动--MSP430单片机 已经通过验证-USB drive- MSP430 single chip microcomputer has been validated

利用DS18B20采集温度，显示温度到lcd上-DS18B20 collected using temperature, shows that the temperature on the lcd

C51bbs上的字模软件，试用版。做液晶显示必备软件。-C51bbs the Fonts software, beta version. Do LCD necessary software.

详细介绍了pic单片机c语言编程的方法和技巧-detail the pic microcontroller c language programming methods and techniques

3字节4字节浮点数转换程序，用来解释单片机的浮点数-3 bytes 4 bytes float switching procedures used to explain SCM float