Keil

开发硬件电路需要用到液晶显示模块1602的用户必备。调试实验源程序第三部分。-Hardware needed to develop liquid crystal display module 1602 required the user. The third part of the experimental source code debugging.

在LCD12864液晶屏上显示曲线，曲线走势为数值大小，曲线连接自然美观-The LCD12864 LCD display curves, the trend for the value of the size of the curve connecting the natural beauty

STC89C58RD+的内部EEPROM读写程序-STC89C58RD+ Internal EEPROM read and write procedures

C code for DS1302 RTC control

自己编写的一个应用于1602液晶的秒表小程序，使用了T0定时器功能，大家喜欢的可以-I have written a stopwatch used in small liquid crystal 1602, the use of the T0 timer function, we can look at like

汇编程序，利用单片机液晶1602实现数字频率计-Assembler, using 1602 single-chip LCD digital frequency meter

nRF9E5的性能测试程序,该程序控制开发板的一个灯的亮与灭.-nRF9E5 the performance test procedures, the control of a development board with the bright lights out.

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

ucos-ii在C8051F020上的移植-ucos-ii on C8051F020 transplant

可用于 51系列单片机与触摸屏之间的通讯 （一般用modbus实现通讯）-design for exchange massage both mcu51 and torch pad