USB驱动程序和FPGA VGA接口

由verilog编写的乘法器，通过两个文件的调用实现。由于子模块的调用使得程序简化了许多。(Prepared by the Verilog multiplier, through the realization of the two documents call. As the sub-modules to simplify the procedure call makes a lot.)

System Verilog decodificator. Enters a value(binary), drops hundreds, tens and units in BCD

基于FPGA的DDS信号源设计，32位相位累加器，产生可调频率(FPGA-based DDS signal source design, 32-bit phase accumulator to generate tunable frequency)

基于System Generator的图像处理工程,多媒体处理FPGA实现的源码,图像增强处理,平滑,锐化,滤波(System Generator based image processing engineering, multimedia processing FPGA implementation source code, image enhancement, smoothing, sharpening, filtering)

用verilog实现的一个2抽头RLS自适应滤波器的代码(A realization with verilog HDL code of a two-tap RLS adaprive fliter )

说明：  用于实现上位机与下位机之间通过RS232协议来进行通讯。(It is used to realize communication between upper computer and lower computer through RS232 protocol.)

此压缩包里面有基于vivado平台的工程，包括了正弦信号的产生，还有fir滤波器的设计以及fft算法的设计实现(in this package,there are three projects of the generation of the signal of sin and the design of fir filter and the ari)

控制8个发光二极管中的一个发光二极管发光，其它7个发光二极管都出于截止状态，发光二极管的导通顺序按照向左或向右两个方向移动，并且通过按键控制发光二极管循环发光移动的方向。(Control of a light-emitting diode light-emitting eight light-emitting diodes, the other seven light-emitting diodes for the cut-off state, light-emitting diode conduction order in accordance with the left or right move in both directions, and light-emitting diode cycle luminous button control mobile direction.)

基于 hdl语言的re232通信实验的设计，程序简单明了，一学就会(rs232 communication)

实现SVPWM的算法实现和仿真，基于FPGA平台用VHDL语言编写(Realization and Simulation of algorithm for realizing SVPWM)