Uart (from the way)

扬创YC_2440_ADS_TEST工程源码，可直接使用H_JTAG调试 -Yang Chong YC_2440_ADS_TEST project source code can be used directly H_JTAG debugging

ARM外围FLASH 以及SDRAM烧写程序 完整的程序 可能对大家硬件编程有点帮助-ARM SDRAM external FLASH and the integrity of the process of burning the procedures we might have the hardware programming help point

这是LPC2119/2129/2292/2294通用的SPI通讯程序，供大家参考。直接可以使用。-This is LPC2119/2129/2292/2294 generic SPI communication procedures, for your reference. Can be used directly.

AT9261在ADS下面的8个代码，一般网站只提供3个代码！-AT9261 in ADS the following 8 code, the general site code only 3!

通常我们需要将板上的Flash芯片拆下，用Flash编程器烧写固件程序；这个程序可以通过CCS运行Emu模式直接将程序烧写到flash芯片中。-Usually we need to board the Flash chip removed, Programming with Flash burning device firmware procedures; This procedure can be run through the CCS model Emu directly to the process of burning flash chip.

ARM4510B下的HDLC程序原码-ARM4510B HDLC procedures under the original code

时钟芯片PCF8563的底层驱动，使用I2C接口，基于pic单片机。-The bottom of the clock driver chip PCF8563, I2C interface to use, based on single-chip pic.

使用AIN0和AIN1测量两路直流电压，并将结果通过UART0想PC机发送。-compute and the use of two-way con measuring DC voltage, the results through UART0 sent to PC.

基于armSUMSUNG公司嵌入式处器的启动程序的原代码及相关说明理。-Based on Embedded armSUMSUNG Department

uCOS移植范例,开发人员或嵌入式爱好者可以借鉴。-uCOS transplantation example, developers or embedded lovers can learn from.