uCOS移植范例,开发人员或嵌入式爱好者可以借鉴。

2410 example for calc

AVR做的SD卡读卡器源程序,带电路原理图-AVR to do the SD card reader source, with circuit schematic diagram

ARM学习报告系列――关于arm的一些好文章-ARM study report series-- on the arm of some good articles

at91sam7a3 keil下sdcard驱动-sdcard driver under at91sam7a3 keil

51eda s3c44b0 测试程序-51eda s3c44b0 testing procedures

ARM开发的指导用书，对你有帮助-ARM with the guidance, to help you

采用ks0108或者兼容芯片的128*64点阵液晶屏驱动程序-Ks0108 or compatible chips using 128* 64 dot matrix LCD driver

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4,每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

用ep2c20硬件，通过niosii实现对音频芯片的控制并播放音乐文件。-Use ep2c20 hardware niosii achieved through the control of the audio chip, and play music files.

keilc 下编写的DS1302的简单驱动,-keilc prepared with a simple driver DS1302,