The bottom of the clock driver chip PCF8563, I2C interface to use, based on sing...

开发环境:ADS 1.2/SDT 2.51 GUI测试，由于没有触摸屏，所以将触摸屏的代码给屏蔽了； 请将FS44B0II开发板连接好交叉网线、直连串口线、电源， 并连接好G57液晶屏，同时还要连接好背光电源； 然后在BIOS的命令窗口里面敲netrun命令； 点击FS44B0_G57_uCGUIuC-GUIFS44B0_G57_uCGUI_DataDebugRel目录下： 批处理文件FS44B0_G57_uCGUI.BAT 下面你就可以看到液晶屏上面显示优龙标志 它会延时一两秒中进入下一个画面，逐步延时GUI的各项功能，请耐心观看； -Development Environment: ADS 1.2/SDT 2.51GUI test, because there is no touch screen, it will be touch screen to shield the code Please FS44B0II development board to connect a good cross-network lines, direct serial lines, power supply, and connect a good G57 LCD screen, at the same time, good backlight power supply connection and then in the BIOS command window knock netrun order Click FS44B0_G57_uCGUIuC-GUIFS44B0_G57_uCGUI_DataDebugRel directory: batch file FS44B0_G57_uCGUI.BAT below you can see the LCD screen above shows excellent signs that it will delay Liuzhou 1 two seconds to enter the next screen, and gradually delay the GUI features, please be patient watch

s3c44b0X,LCD测试程序，分别进行黑白、4级灰度、16级灰度和256色伪彩屏测试-s3c44b0X, LCD testing procedures were black and white, gray 4, 16 and 256 gray pseudo-color screen test

很不错的资料。给打大家共享-very good information. To beat up share

一种基于51单片机的plc下位机程序，完全兼容fx1n plc。高度集成c语言学习。

使用硬件SPI接口与74HC595连接，控制74HC595驱动8个LED流水灯显示。-use of hardware and Bit SPI interface connectivity, control Bit-eight LED lights indicate water.

MIPS Simulator assembly languge.

一个小的ARM源码-A small ARM-source

在ARM7处理器S3C444B0X上的脉搏测量仪程序 ，带LCD显示和触摸屏-S3C444B0X the ARM7 processor on the pulse measurement instrument procedures, with LCD display and touch screen

8051下的I2C驱动软件，可以自由使用。C/C++。-8051 under the I2C driver software can be freely used. C/C.

write flash through jtag for s3c4510