This is an FPGA

说明：  ? 熟悉IIC协议总线协议，采用IIC总线对图像采集传感器寄存器进行配置，并转换为RGB565格式。 ? 利用异步FIFO完成从摄像头输出端到SDRAM 和SDRAM 到VGA 接口各跨时钟域信号的传输和处理。 ? 利用 SDRAM 接口模块的设计，实现了刷新、读写等操作；为提高SDRAM 的读写带宽，均采用突发连续读写数据方式；并采用乒乓操作实现 CMOS 摄像头与VGA的帧率匹配。 ? 利用双线性插值方法实现对图像640×480到1024×768的放大操作。 ? 完成VGA显示接口设计。(Familiar with IIC protocol bus protocol, IIC bus is used to configure the register of image acquisition sensor and convert it into RGB565 format. Asynchronous FIFO is used to transmit and process signals across clock domain from camera output to SDRAM and SDRAM to VGA interface. With the design of SDRAM interface module, refresh, read and write operations are realized. In order to improve the read and write bandwidth of SDRAM, burst continuous read and write data mode is adopted, and table tennis operation is used to achieve frame rate matching between CMOS camera and VGA. The bilinear interpolation method is used to enlarge the image from 640*480 to 1024*768. Complete the VGA display interface design.)

以嵌入式CPU和FPGA为基础的嵌入式系统架构-Embedded CPU and FPGA-based embedded system architecture

fir filter 程序 老师上课留的作业，在这里跟大家分享一下，希望能有所帮助(fir filter procedures teacher in the class to stay the operation here to share with you, hope can be helped)

EDA 正弦信号发生器：正弦信号发生器的结构有四部分组成，如图1所示。20MHZ经锁相环PLL20输出一路倍频的32MHZ片内时钟,16位计数器或分频器CNT6，6位计数器或地址发生器CN6，正弦波数据存储器data_rom。另外还需D/A0832（图中未画出）将数字信号转化为模拟信号。此设计中利用锁相环PLL20输入频率为20MHZ的时钟，输出一路分频的频率为32MHZ的片内时钟，与直接来自外部的时钟相比，这种片内时钟可以减少时钟延时和时钟变形，以减少片外干扰 还可以改善时钟的建立时间和保持时间，是系统稳定工作的保证。CNT6用来将32MHZ进行8分频得到4096HZ的频率提供给CN6与data_rom时钟信号。由CLK端输入20MHZ的时钟信号，在DOUT端就可输出稳定的正弦信号。(Sine signal generator has the structure of four parts, as shown in figure 1 below. The 20 MHZ phase lock loop PLL20 output all the way of frequency doubled within 32 MHZ slice clock, 16 counter or prescaler CNT6, six counter or address generator CN6, sine data storage data_rom. In addition to D/A0832 (shown in not draw) will digital signal into analog signals. This design using the phase lock loop PLL20 input frequency for 20 MHZ clock, the output of the frequency of all points frequency of 32 pieces (MHZ clock, and comes directly from the external clock, compared to this piece of clock can reduce the clock in delay and clock deformation, to reduce the interference of Can also improve the establishment of the clock time and keep time, is the system stability of assurance. CNT6 used to will and to 8 MHZ get 4096 HZ dividing the frequency to provide CN6 and data_rom clock signal. The input by CLK 20 MHZ clock signal, in DOUT end can output stable sine signals. )

基于LabVIEW FPGA的频谱估计与分析(the power spectrum estimation and analysis based on LabVIEW FPGA)

说明：  Arty Z7 20 HDMI output

基于cycloneIIFPGA芯片Ep2c5t144c8的解调程序，用VHDL语言生成-CycloneIIFPGA chip-based demodulation Ep2c5t144c8 procedures, using VHDL language generation

彩色空间转换，RGB和YUV互转的matlab源码(RGB converting to YUV, YUV converting to RGB, Matlab source code)

合并单元内GPS同步时钟的检测 合并单元内GPS同步时钟的检测-Combined unit GPS clock synchronization detection unit merger GPS synchronized clock detection

详细设计了异步fifo格雷码中地址码的生效和Man标志的出现